- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 359
Section 08 DRIVE SYSTEM
Subsection 03 (DRIVEN PULLEY)
Install slider shoes as per following photo. Red
slider shoes are being used for reverse and black
ones for forward.
A30D0WA
1
1
2
2
2
1
1. BLACK slider shoe
2. RED slider shoe
Screws
Screws no. 12 are machined at their end. With
the adjustment ring steel to position 0 (zero),
screw ends are flush with inner side of fixed
pulley half when tighten.
CAUTION: If any of these screws is not flush
with inner side of sliding pulley, bushings will
worn unequally.
Assemble driven pulley components by reversing
the disassembly procedure.
Cam
Coat cam no. 11 interior with Loctite antiseize lu-
bricant (P/N 293 800 070).
INSTALLATION
Countershaft
Apply Loctite antiseize lubricant (P/N 293 800 070)
on countershaft splines.
CAUTION: Always apply antiseize lubricant on
the countershaft before final pulley installation
to prevent a possible seizing up between pulley
and countershaft.
Should installation procedure be required, refer to
BRAKE then look for BRAKE DISC and COUNTER-
SHAFT BEARING ADJUSTMENT.
Reinstall the pulley on the countershaft no. 5 by
reversing the removal procedure.
ADJUSTMENT
Cam
Make sure to install proper cam no. 11. Refer to
TECHNICAL DATA.
Cam angle is identified on cam.
A30D0XA
NOTE: For high altitude regions, a service bulletin
will give information about calibration according to
altitude.
Spring
To check spring preload adjustment, use the
spring scale hook (P/N 529 006 500) and a spring
scale.
529 006 500
Remove drive belt.
mmr2005-088 347
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0