- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 673
Section 04 ENGINE MANAGEMENT (SDI)
Subsection 03 (COMPONENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
If out of specification, replace the sensor.
If resistance tests good, reconnect the ATS and
disconnect the connector A on the ECM.
Using a multimeter, recheck resistance value be-
tween terminals 7 and 21.
If resistance value is correct, try a new ECM. Re-
fer to ENGINE CONTROL MODULE (ECM) in this
section.
If resistance value is incorrect, repair the connec-
tors or replace the wiring harness between ECM
connector and the ATS.
Replacement
Unplug ATS connector.
Pull the ATS out of the air intake silencer.
Spray soapy water on grommet. Install grommet
on air intake silencer then push the sensor in
place.
Reconnect it.
COOLANT TEMPERATURE
SENSOR (CTS)
A35C45A
1
1. Coolant temperature sensor (CTS)
Resistance Test
Disconnect the plug connector from the CTS and
check the resistance of the sensor itself.
A32C9WA
4
3
1
2
Theresistancebetweenterminal1and2isused
for temperature gauge.
Refer to TEMPERATURE SENSOR TABLE at the
beginning of this section to find the corresponding
resistance value for this sensor temperature.
If out of specification, replace the sensor.
Theresistancebetweenterminal3and4isused
for the ECM.
Refer to TEMPERATURE SENSOR TABLE at the
beginning of this section to find the corresponding
resistance value for this sensor temperature.
If out of specification, replace the sensor.
If resistance tests good, reconnect the CTS and
disconnect the connector A on the ECM as well
as the engine/vehicle connector.
A32C9IC
65
ENGINE/VEHICLE CONNECTOR
Using a multimeter, recheck resistance value be-
tweenterminals5and6onengine/vehiclecon-
nector. This resistance is used for temperature
gauge.
152 mmr2005-126
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0