- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 325
Section 07 ELECTRICAL SYSTEM
Subsection 04 (ACCESSORIES)
1
A32H46A
1
TYPICAL
1. Remove screws
Place the accessories panel out of way.
Unplug burnt bulb connector. Remove the rubber
boot.
Turn bulb retainer ring counterclockwise to unlock.
Detach the bulb and replace.
A32H44A
TYPICAL
CAUTION: Never touch glass portion of an
halogen bulb with bare fingers, as it short-
ens its operating life. If by mistake glass is
touched, clean it with isopropyl alcohol which
will not leave a film on the bulb. After lock-
ing ring installation, ensure bulb is properly
secured in place.
Properly reinstall removed parts.
Test
If the new bulb do not work correctly, check con-
nector, wiring harness or HI-LOW beam switch.
Removal
Remove the accessories panel.
Disconnect headlamps.
On RH side of vehicle, remove the push nut then
remove the headlamp housing.
Installation
Reverse the removal procedure.
HEADLAMP BEAM AIMING
Beam aiming is correct when center of high beam
is 25 mm (1 in) below the headlamp horizontal cen-
ter line, scribed on a test surface, 381 cm (12 ft
6 in) away.
Place the vehicle on a flat surface perpendicular to
test surface (wall or screen) and 381 cm (12 ft 6 in)
away from it.
Rider or equivalent weight must be on the vehicle.
Select high beam.
Measure headlamp center distance from ground.
Scribe a line at this height on test surface (wall
or screen). Light beam center should be 25 mm
(1 in) below scribed line.
A02E0AA
1
B
90°
A
TYPICAL
1. Headlamp center line
A. 381cm(12ft6in)
B. 25 mm (1 in) below center line
A02E07A
2
A
1
3
1. Headlamp horizontal
2. Light beam (high beam) (projected on the wall)
3. Light beam center
A. 25 mm (1 in)
mmr2005-085 311
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0