- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 230
Section 05 ENGINE MANAGEMENT (POWER TEK)
Subsection 03 (COMPONENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
COMPONENT INSPECTION,
REPLACEMENT AND ADJUSTMENT
SERVICE TOOLS
Description Part Number Page
Fluke 111.............................................................................. 529 035 868 .........................................213
small hose pinchers .............................................................
295 000 076
................................. 218, 225
GENERAL
Engine problems are not necessarily related to the
engine management system.
It is important to ensure that the mechanical in-
tegrity of the engine/drive systems are present:
– good transmission system operation
– good engine compression and properly operat-
ing mechanical components, no leaks etc.
Check the chart in TROUBLESHOOTING section
to have an overview of problems and suggested
solutions.
When replacing a component, always check its
operation after installation.
ELECTRICAL SYSTEM
It is important to check that the electrical system
is functioning properly:
– battery
– fuses
– power relay
– DESS
– ignition (spark)
– ground connections
– wiring connectors.
It is possible that a component seems to operate
in static condition but in fact, it is defective. In
this case, the best way to solve this problem is
to remove the original part and replace it with one
which is in good condition.
On electric start models, never use a battery
charger to substitute temporarily the battery, as
it may cause the ECM (engine control module) to
work erratically or not to work at all.
Check related-circuit fuse solidity and condition
with an ohmmeter. Visual inspection could lead
to false results.
To perform verifications, a good quality multimeter
such as Fluke 111 (P/N 529 035 868)should be
used.
529 035 868
Pay particular attention to ensure that pins are
not out of their connectors or out of shape. The
troubleshooting procedures cover problems not
resulting from one of these causes.
CAUTION: Ensure all terminals are properly
crimped on wires and connector housings are
properly fastened.
CAUTION: Check if wiring harness shows any
signs of scoring prior to replace the ECM.
mmr2005-107 213
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0