- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 380
Section 08 DRIVE SYSTEM
Subsection 07 (DRIVE AXLE)
REMOVAL
Remove battery (if so equipped) to gain access,
refer to CHARGING section.
Drain oil from chaincase. Remove chaincase cov-
er. Release drive chain tension.
A32D0YA
Raise and block rear of vehicle off the ground.
Remove suspension. Refer to proper subsection.
On some models, track can be held in tunnel using
a rod in place of center idler wheel axle.
A32D0ZA
1
TYPICAL
1. Rod
Remove driven pulley. Refer to DRIVEN PULLEY.
Remove speedometer sensor no. 1, outer flange
no. 2 and circlip no. 3 from left side.
Unscrew then pull speedometer magnetic adapter
no. 4 from drive axle no. 5.
1
A33D17A
1. Circlip
Apply parking brake.
Remove chain and sprockets then circlip from
right side.
Release drive axle sprocket from track and at the
same time, push the drive axle no. 5 toward the
right side. Drive axle bearing in chaincase will fall
off.
Sprocket and Half-Sprocket
To remove press fit sprockets no. 6 and no. 7,use
a press and a suitable support as illustrated.
A33D0LA
1. Support sprocket near hub
mmr2005-092 371
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0