- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 1326
Section08ELECTRICAL
Subsection 06 (TESTING PROCEDURE)
277, 443 and 552 Engines
A05E0KA
1
2
3
MPEM
1. Reverse switch, reverse indicator and trigger coil
2. Trigger coil
3. Generator output and cut-off switches
To ease electrical readings on MPEM connectors,
connector cap must be removed.
Hold connector in hands then lift both tabs to re-
move connector cap.
A05E0GA
LIFT TABS TO REMOVE CAP
Insert multimeter probes into connector.
A05E0LA
TEST USING MULTIMETER PROBES
IGNITION SYSTEM TESTING
SEQUENCE
All Models
In case of ignition problems, check the following
in the prescribed order until the problem can be
solved.
1) Sparking/spark plug condition.
2) Electrical connectors.
3) Ignition switch, DESS switch or tether cut-out
switch and engine cut-out switch.
4) Ignition generator coil.
5) Trigger coil.
6) MPEM voltage (liquid cooled engines only).
7) High voltage coil (liquid cooled engines only).
8) Buzzer testing.
LIGHTING SYSTEM TESTING
SEQUENCE
1) Electrical connectors.
2) Magneto output (lighting generator coil).
Testing Conditions
Voltage measurements are always taken upon
starting the vehicle. Readings taken when the
engine is running will be higher than indicated
range.
Part temperature must be approximately 21°C
(70°F) (room temperature), otherwise readings
could be distorted.
468 mmr2005-047
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0