- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 598
Section02ENGINE
Subsection 08 (BOTTOM END)
A35C1JA
Crankshaft Installation
NOTE: Although not mandatory, it is recommend-
ed to have the coolant/oil pump shaft installed pri-
or to installing crankshaft.
At crankshaft installation, position locating pins as
illustrated.
A35C1KA
1
1. Locating pins
Pour 50 mL (2 U.S. oz) of injection oil in the pan
under worm gear to lubricate pump gearing.
1
A32C0DA
TYPICAL
1. Oil bath
Counterbalance Gear
Make sure to properly index gears of crankshaft
and counterbalance shaft with the aligning marks.
CAUTION: Marks on the gears must be aligned,
otherwise engine will vibrate and premature
wear will occur.
A35C4KA
1
1. Marks on gears aligned
Apply 40 mL (1.4 on) of Isoflex grease on counter-
balance shaft gear no. 9 and5mL(.2on)ondrive
gear no. 7. Repeat on each side (PTO/MAG).
CAUTION: Use only the recommended Isoflex
grease.
NOTE: If it is necessary to add grease when
crankcase is assembled, remove caps no. 20 and
apply grease through the filling nipples.
Install caps no. 21.
Crankcase Assembly
IMPORTANT: The total assembly sequence, in-
cluding sealing compound spreading, screwing
and torquing of bolts according to the proper
sequence, must be performed within 10 minutes.
Do not wait between each bolt torquing. All bolts
mustbetorquedinarow.
NOTE: It is recommended to apply the specific
sealant as described here to get an uniform appli-
cation without lumps. If you do not use the roller
method, you may use your finger to uniformly dis-
tribute the sealant.
72 mmr2005-118
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0