- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 461
Section 10 STEERING/FRONT SUSPENSION
Subsection 02 (FRONT SUSPENSION)
10° ± 3°
A33F2IB
Lower Arm
Position lower arm below stabilizer bar.
Prior to installing ball joint in lower arm, ensure to
clean the tapered surfaces with the pulley flange
cleaner (P/N 413 711 809). Surface contacts must
be clean and free of dirt, oil and grease. Apply
the cleaner on a rag then use the rag to clean the
surfaces of ball joint and ski leg.
To install ball joint, proceed as follows:
– Install ball joint support (P/N 529 035 875) on
top side of lower arm (operating position).
– Position ball joint installer (P/N 529 035 975) on
bottom side of lower arm (operating position).
– Press joint in.
– Install snap ring no. 13 with its opening toward
front of vehicle.
529 035 975
A33F29B
529 035 875
To properly torque ball joint nut, use the A-arm nut
wrench (P/N 529 035 876).
529 035 876
A33F2AA
Ensure to install the tool perpendicularly (90°)to
torque wrench.
1
A33F22A
A
1. Tool perpendicular (90°)totorquewrench
A. 90°
A33F2KA
Use ball joint lock tool (P/N 529 035 945) to restrain
ball joint during nut tightening.
NOTE: The upper arm ball joint has to be removed
in order to use this tool. Also remove the small
screw from top of ball joint to allow proper seating
of tool.
456 mmr2005-098
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0