- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 239
Section 05 ENGINE MANAGEMENT (POWER TEK)
Subsection 03 (COMPONENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
Resistance Test
Refer to TEMPERATURE SENSOR TABLE at the
beginning of this section.
Disconnect sensor connector and measure sensor
resistance. If out of specifications, replace sen-
sor.
If resistance tests good, reconnect the ATS and
disconnect the ECM connector.
A34E0LB
32
17
16
1
ECM CONNECTOR
Using a multimeter, measure resistance value
again between terminals DA-19 and DA-1.
If resistance value is correct, try a new ECM. Refer
to ECM REPLACEMENT procedures elsewhere in
this section.
If resistance value is incorrect, repair the connec-
tors or replace the wiring harness between ECM
connector and the ATS.
Replacement
Unplug ATS connector.
Pull the ATS out of the air intake silencer.
Spray soapy water on ring. Install ring on air intake
silencer then push the sensor in place.
Reconnect it.
COOLANT TEMPERATURE
SENSOR (CTS)
NOTE: A dual sensor is used on this system. It
supplies information to the ECM and to the tem-
perature gauge.
Dynamic Test
Connect vehicle communication kit (VCK) and use
B.U.D.S. software.
Look engine temperature in Monitoring tab of
B.U.D.S. It should show the coolant temperature.
Otherwise, perform the following test.
A33C5CA
Resistance Test
Refer to TEMPERATURE SENSOR TABLE at the
beginning of this section.
CTS Sensor for EMS
Disconnect sensor connector and measure sen-
sor resistance between BLACK/GREEN and
BEIGE/ORANGEwiresofsensor. Ifoutofspeci-
fications, replace sensor.
If resistance tests good, reconnect the CTS and
disconnect the ECM connector.
Measure resistance value again between termi-
nals DA-1 and DA-21 on ECM connector.
If resistance value is correct, try a new ECM. Refer
to ECM REPLACEMENT procedures elsewhere in
this section.
222 mmr2005-107
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0