- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 1212
Section 07 TRANSMISSION
Subsection 02 (DRIVE PULLEY)
A03D2IA
1
1. Alignment marks
Identify blocks no. 1 and their respective positive
positions for reassembly.
A05D0LA
1
1
1. Identify
2, Cap, Washer and Disk
These are calibration parts. Refer to TECHNICAL
DATA.
Install spring cover tool (P/N 529 027 300) with
TRA drive pulley puller (P/N 529 022 400) on spring
cover.
A03D2HA
2
1
1. Puller tool
2. Spring cover tool
Screw puller (hand tight) to hold spring cover and
remove screws holding spring cover.
Slowly unscrew puller to release spring pressure.
Remove spring cover no. 5, spring and spring seat
no. 11.
CLEANING
Clean pulley faces and shaft with fine steel wool
and clean dry cloth. Clean sliding half bushing
with clean dry cloth.
INSPECTION
Check sliding half for excessive lateral play and
fixed half shaft for scratches. Replace as required.
ASSEMBLY
Install spring seat no. 11 thenthespringandits
cover no. 5.
Make sure to install blocks in their original position
and with their curved end toward governor cup.
See following illustration.
348 mmr2005-035
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0