- Тип техники
- Бренд
Просмотр инструкции материнской платы Gigabyte GA 73PVM S2 rev 1 0, страница 72
GA-73PVM-S2 Motherboard - 72 -
B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Under Integrated Peripherals, ensure NV Serial-ATA Controller is enabled (Figure 1). Then, go to
the SATA-II RAID Config submenu (Figure 2).
Figure 1
The BIOS Setup menus described in this section may differ from the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
Step 2:
Save changes and exit BIOS Setup.
To create a RAID array, set Onchip SATA Mode to RAID (or set to IDE or AHCI for non-RAID
configuration). Then, enable RAID functionality for the SATA connectors with hard drives that you want
to use for RAID. For example, SATA-II Pri-Master RAID is for the SATAII0 connector and SATA-II Pri-
Slave RAID for the SATAII1 connector. (Figure 2).
Figure 2
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
Integrated Peripherals
On-Chip IDE Channel0 [Enabled]
IDE Prefetch Mode [Enabled]
NV Serial-ATA Controller [All Enabled]
` SATA-II RAID Config [Press Enter]
On-Chip MAC Lan [Auto]
Onboard LAN Boot ROM [Disabled]
Onboard Audio Function [Auto]
On-Chip USB [V1.1+V2.0]
USB Memory Type [SHADOW]
USB Keyboard Support [Disabled]
USB Mouse Support [Disabled]
HDMI Audio [Auto]
` SMART LAN [Press Enter]
Legacy USB storage detect [Enabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [SPP]
x ECP Mode Use DMA 3
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level`
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
SATA-II RAID Config
Item Help
Menu Level``
Onchip SATA Mode [RAID]
SATA-II Pri-Master RAID [Enabled]
SATA-II Pri-Slave RAID [Enabled]
SATA-II Sec-Master RAID [Disabled]
SATA-II Sec-Slave RAID [Disabled]
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Ваш отзыв будет первым