- Тип техники
- Бренд
Просмотр инструкции измерительного прибора Condtrol DeuX, страница 33
33
CONDTROL DeuX/UniX
2
/UniX
3
/UniX
5
User Manual
CROSS LINE
LASER
to wait until the temperature aligns.
• Protect the instrument from blows and falls. After a strong external
influence on the instrument it is always necessary to check accuracy before
starting the work again (See «Accuracy Check»).
• Switch off the instrument during transportation. Always switch the On/Off
(D) to the right position. When switching off, the leveling unit, which can be
damaged in case of intense movement, is locked.
Switch on/off
Move switch the On/Off (D) to upper position.
By consecutive pressing 1 the instrument is switched to the different
operating modes displayed on the keypad (horizon; vertical; horizon and
vertical at the same time; defining of directions; horizon, vertical, defining
of directions at the same time).
To work with the automatic compensation switch on the instrument as it
is described above and switch the On/Off (D) to the outside left position.
Switching of the operating modes also is made by pressing 1.
At a low charge of the batteries the indicator 3 flashes red.
- Do not direct the laser beam on people or animals and do not look in the
laser beam, even from a long distance.
- Do not leave the switched-on instrument unattended and switch it off after
using.
To switch off the instrument move the On/Off (D) to the lower position, at this
the leveling unit is blocked.
Operating Modes (see fig. A-D)
The instrument has five operating modes:
The horizontal mode - produces a horizontal laser line.
The vertical mode - produces a vertical line.
The mode of crossing lines - produces a horizontal and vertical line.
The mode of constructing of directions - produces five (Unix5 only)
orthogonal directions/ free (Unix3 only) orthogonal directions/ two
(Unix2 only) directions.
The mode of constructing of crossing lines and orthogonal directions
(Unix only).
After switching on the instrument is in the horizontal line mode. Press 1 to
change the operating mode.
All five modes can be switched on both with the automatic compensation,
and without the automatic compensation.
Automatic Compensation
Operation with the automatic compensation (see fig. C)
Place the instrument on a horizontal, solid surface or fix it on a tripod.
Move the On/Off (D)
to the upper position to work with the automatic
compensation.
The compensator automatically aligns a position within the range of
compensation ±5°. The laser beam star ts to blink when the instrument is out
of the range of the automatic compensation, signaling that the instrument
is out of the self-alignment range. In that case place the instrument
horizontally and wait for the end of the automatic compensation.
At pushes and position changes during the work the instrument
automatically does the compensation. Check up a horizontal and vertical
position of the laser lines in relation to the reference points after a repeated
compensation to prevent from errors.
Ваш отзыв будет первым