- Тип техники
- Бренд
Просмотр инструкции увлажнителя воздуха Vitek VT-2335 BK, страница 4
4
ENGLISH
a person who is responsible for their safety or
if they are not instructed by this person on the
usage of the unit.
• Do not leave children unattended to prevent
using the unit as a toy.
• For children safety reasons do not leave poly-
ethylene bags, used as packaging, unat-
tended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger of
suffocation!
• Never pull the power cord when disconnect-
ing the unit from the mains; take the power
plug and carefully pull it out of the mains
socket.
• Never use the unit if the power cord or the
power plug is damaged, if the unit works
improperly or after it was dropped.
• Do not attempt to repair the unit. Do not disas-
semble the unit by yourself, if any malfunction
is detected or after it was dropped, unplug
the unit and apply to any authorized service
center from the contact address list given in
the warranty certificate and on the website
www.vitek.ru.
• Transport the unit in the original package only.
• For environment protection do not discard the
unit with usual household waste after its ser-
vice life expiration; apply to a specialized cen-
ter for further recycling.
• Keep the unit out of reach of children and dis-
abled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
BEFORE THE FIRST USE
After unit transportation or storage under
cold (winter) conditions, it is necessary to
keep it for at least three hours at room tem-
perature.
There may be water spots in the air humidi-
fier, this is normal, as the unit has undergone
factory quality control.
– Unpack the unit, remove any stickers and
package materials that can prevent unit oper-
ation. Check the unit for damages. In case of
damages do not switch the unit on.
– Before plugging the unit in make sure that
your home mains voltage corresponds to the
unit operating voltage.
Notes:
Use the air humidifier at the room temperature
from +10° С to +40°С, and relative humidity less
than 80%.
Water temperature should not exceed +40°С.
USING THE AIR HUMIDIFIER
– Remove the nozzle (7).
– Take the water tank by the handle (8) and
remove it from the unit body (12).
– Turn over the tank (6), unscrew the lid (11)
rotating it counterclockwise.
– Fill the tank (6) with necessary amount of
water, insert the lid (11) into the water inlet (9)
and screw it rotating clockwise.
– First place the filled water tank (6) back to its
place and then install the nozzle (7).
– Wait till the process chamber (4) is filled with
water.
Note:
– Before the first use it is recommended to put
the mineral filter (10) into a container filled
with water of room temperature for several
minutes.
– Remove the filter (10) from the lid (11) turn-
ing it counterclockwise, put the filter (10) into
water for several minutes, take the filter out
and drain the remaining water, then install it
back on the lid (11), turning it clockwise until
bumping.
– Insert the power plug into the mains socket.
– Switch the unit on touching the button (13),
you will hear a sound signal and the unit
will be switched on with the maximal «mist»
release intensity; the following icons will be
shown on the display (2): relative room humid-
ity icon (19), «mist» release intensity icon (20),
icon crawline (23).
– To switch the air humidifier off touch the but-
ton (13) again.
– Unplug the unit.
Notes:
– The operation mode selection and setting
buttons on the control panel (3) are sensory,
you just need to touch the button to switch the
necessary operation mode on.
– The humidity level icons (19) shown on the
display (2) may be slightly different from the
readings of another hygrometer.
– The humidity level indications depend on the
room temperature.
IM VT-2335.indd 4 27.02.2017 17:35:46
Ваш отзыв будет первым