- Тип техники
- Бренд
Просмотр инструкции кофеварки Vitek VT-1526, страница 6
6
ENGLISH
• Slowly turn the steam supply control knob (3)
«OFF--- +» and fully open the steam supply.
Note: - to avoid splashing milk always immerse
the tip (5) deeper than 1 cm from the milk sur-
face.
• The outgoing steam creates whirls which
froths milk; from time to time lift and lower the
bowl with milk against the tip (5) to make the
milk foam.
• Be careful while operating with outgo-
ing steam; after you finish frothing the milk,
switch the steam supply off by setting the
control knob (3) to the position «OFF».
• Add frothed milk to the cup of coffee.
• Switch the coffee maker off by pressing the
button (13) «
».
Note: - making the milk foam is an art. You may
not make it at the first try, don’t worry and experi-
ment until you achieve good results.
Important:
– It is important that milk for making foam is
fresh and without additives, is not so-called
long storage milk.
– Use regular whole milk with fat content from
4% to 6%, the cream fat content should be
not less than 10%.
– Clean the cappuccinator pipe (4) and its tip
(5) right after milk or cream frothing - to do
this, put the cappuccinator pipe (4) with the
tip (5) into a glass of water, switch the steam
supply on by setting the steam supply knob
(3) to the position «--- +», and after that switch
the steam supply off by setting the steam sup-
ply knob (3) to the position «OFF» and switch
the coffee maker off.
– Wait until the coffee maker cools down and
remove the tip (5) from the cappuccinator
pipe (4), wipe the cappuccinator pipe (4) with
a soft damp cloth and wash the tip (5) under
a water jet.
WARMING THE DRINKS
You can warm up your drinks by putting the cap-
puccinator pipe (4) without the tip (5) into the
cup.
• Switch the coffee maker on, press the button
(9) and wait until the boiler heats up (the but-
ton (9) illumination will glow constantly).
• Put the cappuccinator pipe (4) into the cup
with the drink you want to warm up.
• Slowly turn the steam supply control knob (3)
«OFF--- +» and fully open the steam supply.
• When the drink gets up to the required tem-
perature, switch the steam supply off by set-
ting the control knob (3) to the position «OFF».
• Switch the coffee maker off by pressing the
button (13) «
».
HOW TO MAKE A GOOD ESPRESSO
– Use fresh ground coffee for «espresso» cof-
fee makers.
– Slightly tamp the ground coffee in the filter (15
or 16), you can do it with the back side of the
measuring spoon (17).
– Coffee strength depends on the quality and
grinding degree of coffee beans. If coffee is
pouring out too long, this means the coffee
powder is too fine or it is tamped too strongly.
DESCALING
For effective operation of the coffee maker we
recommend removing scale every 2-3 months
and more often when using «hard» water.
1. Make citric acid solution: 2 teaspoons of acid
to 1 litre of water.
2. Fill the water tank (2) with the solution. Install
the water tank (2) to its place.
3. Insert the coffee filter (15 or 16) into the
holder (7).
4. Install the filter holder (7) into the coffee
maker. The filter holder (7) ledges should
match the groves on the boiler, after that turn
the filter holder (7) handle to the utmost right
position «LOCK».
5. Place a suitable cup on the tray grid (6).
6. Insert the power plug into the socket.
7. Switch the coffee maker on by pressing the
button (13) «
».
8. Wait until the button (13) illumination glows
constantly.
9. Press the button (10) « » and fill a cup of
about 100 ml capacity with water (it is neces-
sary to drain the water from the boiler and fill
the boiler with citric acid solution), switch the
water supply off by pressing the button (10)
«
» again.
10. Remove the tip (5) from the cappuccinator pipe
(4) and put a suitable bowl under the pipe (4).
Press the button (9) and wait until the boiler
heats up (the button (9) illumination will glow
constantly). Slowly turn the steam supply
control knob (3) «OFF--- +» and switch the
steam supply on for 10-15 seconds. Switch
the steam supply off by setting the control
knob (3) to the position «OFF».
IM VT-1526.indd 6 28.12.2017 16:03:20
Ваш отзыв будет первым