- Тип техники
- Бренд
Просмотр инструкции кофеварки Vitek VT-1526, страница 5
5
E N G L I S H
• Install the filter holder (7) back to its installa-
tion place. The filter holder (7) ledges should
match the groves on the boiler, after that turn
the filter holder (7) handle to the utmost right
position «LOCK».
• Place the cup on the tray grid (6).
• Insert the power plug into the mains socket.
• Switch the coffee maker on by pressing the
button (13) «
», the button (13) illumination
will light up and start flashing.
• Wait until water in the boiler heats up, the but-
ton (13) will be glowing constantly.
Note: - warm the cups that you want to use first;
to do this, place the cups on the cup warming
tray (14), while water is heated in the boiler, the
tray (14) heats up too, thus warming the cups.
– To make one cup of espresso use a small filter
(16) and press the button (12) «
», the pump
will switch on for 3 seconds for preliminary
soaking of coffee; after a pause the pump will
be switched on and operate for 20 seconds.
– To make two cups of espresso use a big fil-
ter (15) and press the button (11) «
», in
this case set one big or two small cups on the
grid (6). When you press the button (11), the
pump will switch on for 3 seconds for pre-
liminary soaking of coffee; after a pause the
pump will be switched on and operate for
40 seconds.
– If necessary, you can set up the pump oper-
ation time, in this case the amount of ready
coffee will be different. To set up the pump
operation time press the button (11 or 12)
and hold it, when the cup is filled to the nec-
essary amount, release the button (11 or 12)
and immediately press it again. Next time the
coffee maker will make the preset amount of
ready coffee.
Note: - maximal possible operation time of the
pump is 45 seconds for one cup and 90 seconds
for two cups.
– To switch back to the default settings switch
the coffee maker off and unplug it, when you
switch the unit on next time, the coffee maker
will switch back to the default amount of ready
drink.
Note:
– if you need to switch the water supply off dur-
ing the coffee making, press the button (11
or 12) again;
– successive making of coffee should be per-
formed with 2-3 min intervals;
– control the tray (6) filling, periodically pour out
the liquid and wash the tray (6).
• Switch the coffee maker off by pressing the
button (13) «
».
• Wait until the coffee maker cools down and
remove the filter holder (7), turning the holder
(7) handle to the left until bumping. Remove
the ground coffee remnants and wash the fil-
ter (15 or 16). For easy removing of the coffee
remnants use the retainer (8) to prevent the
filters (15 or 16) from falling off the holder (7).
MAKING CAPPUCCINO
Attention! Be careful not to get burns by
the outgoing steam from the cappuccinator
pipe (4) and the removable tip (5).
• Make coffee, as described in the chapter
«MAKING ESPRESSO», in the warm cup with
enough capacity to add frothed milk.
Note:
– it is recommended to make the necessary
amount of espresso before frothing the milk,
because the water temperature in the steam
supply mode is higher than temperature of
water intended for making espresso, so the
ready drink may taste different;
– it is recommended to make the next cup of
espresso in 5-10 minutes after frothing the
milk;
– you can reduce the time of the water tem-
perature decreasing, to do that place a cup
under the filter holder (7) (do not add ground
coffee to the filter (15 or 16)) and switch the
manual supply on by pressing the button (10)
«
», after the cup is filled press the button
(10) again to switch the water supply off.
• Press the steam supply on button (9) « »
and wait until the button (9) illumination stops
flashing and glows constantly.
• Place a suitable cup under the tip (5), care-
fully turn the steam supply control knob (3)
«OFF--- +» and drain the remaining water and
condensed moisture from the cappuccinator
pipe (4), make sure that the outgoing steam is
homogenous and without water.
• Switch the steam supply off by setting the
steam supply knob (3) «OFF--- +» to the posi-
tion «OFF».
• Put the tip (5) into the bowl with cold milk or
cream, the tip (5) must not touch the bottom
of the bowl otherwise the steam outgoing will
be hindered.
IM VT-1526.indd 5 28.12.2017 16:03:20
Ваш отзыв будет первым