- Тип техники
- Бренд
Просмотр инструкции лодочные моторы Suzuki DF115, страница 36
_________________________________________________________________________
Перевод выполнил официальный представитель Suzuki Marine на Дальнем Востоке,
компания ООО «1000 Размеров» (www.suzukimarine.ru)
36
1. Install the flushing attachment 1 so that
the
water intake holes are covered by the rubber
cups on the attachment.
2. Connect a garden hose to the flushing at-
tachment
and turn on the water to obtain
enough flow so that plenty of excess water is
flowing out from around the rubber cups on
the attachment.
3. Place the remote control lever in the
“NEUTRAL”
position, start the motor and allow it
to run at idle.
4. Readjust the water flow, if necessary, so
that
there is still plenty of excess water flowing
out from around the rubber cups.
5. Allow the water to continue circulating
for a
few minutes.
6. Stop the motor, then turn off the water.
7. Remove the flushing attachment from the
water intake hole.
8. Clean the motor surface and apply a coat
of
automotive wax on the external finish of the
motor.
ENGINE NOT RUNNING – Vertical
position –
1. Remove the plug A from the flushing
port.
2. Install garden hose by using a hose con-
nector matched to flushing port thread B.
(Thread B: 0.75 – 11.5 NHR (ANSI))
A suitable connector is commercially avail-
able at most hardware outlets in U.S.A.
3. Turn on the water to obtain a good water
flow. Flush the engine for about five mi-
nutes.
4. Turn off the water.
5. Remove the hose and connector (if used)
then reinstall the plug into the flushing port.
6. Leave the motor in a vertical position un-
til the engine is drained completely.
ENGINE NOT RUNNING – Full tilt up
position –
1. Raise the engine to the full tilt up posi-
tion.
2. Follow the “ENGINE NOT RUNNING –
Vertical position” instructions.
DO NOT RUN ENGINE IN THE FULL
TILT UP POSITION.
3. Lower the motor to a vertical position un-
til the engine is drained completely.
Ваш отзыв будет первым