- Тип техники
- Бренд
Просмотр инструкции соковыжималки Vitek VT-3668, страница 5
5
E N G L I S H
• Feed fruit/vegetable pieces into the lid (3)
feeding chute (2) only when the grating fil
-
ter (4) is rotating.
• Gradually put vegetables or fruits cut
beforehand into the lid (3) feeding chute (2)
and push them gently with the pusher (1).
Do not press on the pusher (1) too hard as
it can lead to decrease of juice amount as
well as stop the grating filter (4) rotation. The
slower is the fruit and vegetables process
-
ing, the higher is the juice extraction rate.
• Do not put your fingers or any other foreign
objects into the lid (3) feeding chute (2).
• During operation, check the grating filter (4)
periodically for obstruction of the mesh with
pulp, if necessary wash the grating filter (4);
before removing the grating filter (4), switch
the juice extractor off and unplug it.
• Control the pulp container (10) filling, if the
container (10) is filled up, switch the juice
extractor off, unplug it and remove the pulp
from the container.
Note: - during the breaks between opera
-
tion or after filling the juice cup (11) turn the
spout (6) to the right until bumping “
”, so the
juice will not drip on the table.
ATTENTION!
The maximal allowable continuous opera
-
tion time for the juice extractor is 1 minute
with subsequent break of at least 1 minute.
After 3 operation cycles make a break of at
least 15 minutes.
After processing of 500 g hard and fibrous
fruits and vegetables (citrus plants, pine
-
apples, apples, carrots etc.) disassem-
ble and clean the unit. Non-compliance
with the requirement can cause the grat
-
ing mesh blockage and will complicate the
unit cleaning.
• After unit operation, switch it off by set-
ting the switch (9) to the position «0», and
unplug it.
OVERHEATING PROTECTION
The overheating protection system will switch
the power supply off if the electric motor oper
-
ating temperature is too high. If during the
operation the juice extractor switches off, set
the operation mode switch (9) to the position
«0» and unplug the unit.
Let the juice extractor cool down for 30-40 min
-
utes and switch it on again.
Do not exceed specified operation time and do
not overload the juice extractor with products
during its operation.
CLEANING AND CARE
After the end of operation or before cleaning
always switch the unit off and unplug it.
Disassemble and clean the juice extractor
after every usage and follow the recom
-
mendations below.
• Remove the pusher (1) from the lid (3) feed-
ing chute (2).
• Lower the lock (7) and remove the lid (3).
• For easy removal of the grating filter (4)
remove the grating filter with the juice col
-
lector (5) holding the juice collector (5) and
pulling it upwards.
• Set the spout (6) to the middle position and
remove it.
• It is recommended to wash all removable
parts in warm water with a neutral detergent
right after the unit operation.
• It is more convenient to wash the grating fil-
ter (4) openings from the outside using an
appropriate brush.
• Be cautious when washing the grating fil-
ter (4), the disc grating surface is very
sharp.
• Do not wash the grating filter (4) and other
removable parts in a dishwasher.
• Clean the motor unit (8) with a slightly damp
cloth and then wipe it dry. Do not immerse
the motor unit (8) into water or any other liq
-
uids; do not wash the motor unit (8) under
water jet.
• Do not use coarse sponges, abrasives and
solvents to clean the unit.
• Some products, such as carrots or beets,
can dye the juice extractor’s removable
parts, you can use a dry cloth dampened
in vegetable oil for removing stains; after
cleaning of parts wash them with warm
water and a neutral detergent, then dry.
• Assemble the juice extractor.
TIPS
• Use only fresh fruits and vegetables, as they
contain more juice.
• For juice extracting you can use different
vegetables (carrots, cucumbers, beets,
celery stems, spinach, tomatoes) or fruits
(apples, grapes, pineapples).
IM VT-3668.indd 5 28.01.2019 11:41:52
Ваш отзыв будет первым