- Тип техники
- Бренд
Просмотр инструкции пылесоса Vitek VT-1845 R/B, страница 7
7
ENGLISH
After the cleaning is completed switch the ap-
pliance off immediately.
Crevice nozzle (27)
This nozzle is intended for cleaning of the ra-
diators, crevices, corners and spaces between
sofa pillows.
Small brush (28)
This nozzle is intended for collecting the dust
from the surface of the furniture. The nozzle is
equipped with the nap, which is to prevent your
furniture from scratching and other damages.
Nozzle for cleaning the furniture coverings
(29)
The nozzle is intended for cleaning the cover-
ings of your furniture.
Floor/carpet brush (30) (Pic.5-6)
Turn the switcher on the brush to the required
position (depending on the type of the surface
you need to clean).
Operating instructions
Before using the appliance, unwind a sufficient
length of the power cord and insert the plug into
the wall outlet. Yellow mark on the power cord
indicates the maximum length of the cord. Do
not expend the cord beyond the red mark.
Attention!
Always switch the appliance on only if dust
collecting container (7) and filters (13, 14)
are installed properly.
1. Push ON/OFF button (12) to switch the ap-
pliance on.
2. While operating you can adjust the suction
power by turning the mechanical regulator
located on the flexible hose handle (3).
3. After the cleaning is completed press ON/
OFF button (12) to switch off the vacuum
cleaner and then unplug its power cord from
the wall outlet.
4. To rewind the power cord press button (11).
Hold the winding cord by the hand to escape
damages.
5. During the breaks use the parking place (17)
to store the brush.
MAINTENANCE
1. Detaching dust collecting container (7)
and removing the dust and trash (Pic. 7, 8)
• Switch off the vacuum cleaner and unplug
the power cord from the wall outlet.
• Hold the handle of the dust collecting con-
tainer (8), press the button (9), and detach
the container.
• Open the protecting cap (20) by pulling it up-
wards, and press the lower cap opening but-
ton (21).
• Remove the dust and trash out of the con-
tainer.
Notice
- It is recommended to clean the container
every time after using the appliance.
- If green indicator (15) is on, the vacuum
cleaner is working properly.
- If the dust collecting container is full, the
red indicator (16) is flashed. In this case you
should clean the dust collecting container.
2. Disassembling dust collecting container
(7) (Pic. 9, 10)
• Switch the vacuum cleaner off and unplug the
power cord from the wall outlet. Press button
(9) and detach dust collecting container (7),
remove the dust and trash out of it, and close
the lower cap (24).
• Pull the latch (25) towards yourself, and re-
move the detachable bulbs (22).
• Wash the detachable bulbs (22) under the
flowing water. In the same way clean the in-
ner separators (26).
• Before assembling the dust collecting con-
tainer (7) dry the bulbs and the separators
carefully.
Assembling dust collecting container
- Install the inner separators (26) into the de-
tachable bulbs (22) thus the latch (25) is
locked.
- Install the dust collecting container (7) at its
former place.
3. Cleaning the filters (Pic. 11)
Watch if the filters (13, 14) are clean, as the ef-
fectiveness of the vacuum cleaner operation
depends upon it.
1845.indd 71845.indd 7 14.04.2010 9:29:4514.04.2010 9:29:45
Ваш отзыв будет первым