Просмотр инструкции кофеварки Vitek VT-1525 BK, страница 7
7
E N G L I S H
and slowly turn the knob (15) counterclockwise
to adjust the steam supply intensity at your dis-
cretion. The tip of the cappuccinator pipe should
not touch the bottom of the tumbler, as this can
prevent the steam release. With certain skill you
can make frothed milk in several seconds.
•
Switch the steam supply off by setting the knob
(15) to the position «-».
•
Clean the cappuccinator pipe (18) and its tip
(19) right after milk or cream frothing - to do this,
put the cappuccinator pipe (18) with the tip into
a glass of water, switch the steam supply on by
setting the steam supply knob (15) to the posi-
tion «+», and after that switch the steam supply
off by setting the steam supply knob (15) to the
position «-».
•
Switch the coffee maker off by pressing the but-
ton (9), the indicators (8 and 14) will go out.
•
Wait until the coffee maker cools down and
detach the tip (19) of the cappuccinator pipe
(18), turning the tip (19) in different directions
and wash (rinse) it under a water jet.
Note: The next time you make coffee, let the cof-
fee maker boiler cool down to required temperature
to avoid the smell of burnt coffee. To do this, follow
the steps below:
–
Switch the additional heating off by pressing the
steam supply button
(13).
–
Place a suitable cup (with a capacity of no less
than 250 ml) on the tray grid (2).
–
Put the tip of the cappuccinator pipe (19) into
the cup.
–
Press the water supply button (12) and switch
the steam supply on by setting the knob (15) to
the position «+». The pump will start running
cold water through the boiler. Water will start
pouring from the outlet openings of the filter
holder (5) and the cappuccinator tip (19). Run
water through the broiler until the ready indica-
tor (14) goes out. You can watch the tempera-
ture decrease on the built-in thermometer (10).
–
After that close the water and steam supply,
press the button
(12), set the knob (15) to
the position «-» and wait until the ready indica-
tor (14) lights up green again.
IMPORTANT:
•
It is important that milk for making milk froth
is fresh and without additives, therefore so-
called long storage milk is not suitable for this
purpose.
Take ordinary whole milk with fat content from 4 to
6%, cream fat content should be not less than 10%.
WARMING THE DRINKS
You can warm up your drinks by putting the cap-
puccinator pipe (18) without the tip (19) into the cup
with the drink.
•
Remove the tip (19) from the cappuccinator
pipe (18).
•
Make sure that there is enough water in the
removable tank (16), the buttons (12, 13) are not
pressed and the steam supply knob (15) is in the
position “-”.
•
Place a suitable bowl on the tray grid (2).
•
Insert the power plug into the mains socket.
Press the button
(9) to switch the coffee
maker on, the indicator (8) will light up red. Press
the button
(12). Make sure that the steam
supply button
(13) is not pressed.
•
Wait until water is delivered from the outlet open-
ings of the filter holder (5), after that stop the water
supply by pressing the button
(12) again.
•
Press the button (13) and wait until the ready
indicator (14) lights up green. It means that the
additional heating of water up to vapor condi-
tion is over.
•
Draw the cappuccinator pipe (18) into the cup
with the drink you want to warm up. If you want to
heat up milk, immerse the cappuccinator pipe tip
(18) into milk by approximately 2 cm, and slowly
turn the knob (15) counterclockwise to adjust the
steam supply intensity at your discretion.
•
After heating up the drink set the knob (15) to
the position «-».
•
Switch the coffee maker off by pressing the but-
ton (9), the indicators (8 and 14) will go out.
Note: The first portion of steam may contain some
water; to obtain dry water steam it is necessary to
release the steam into an appropriate container
during several seconds.
AUTO SWITCH-OFF FUNCTION
After pressing the button
(9) the coffee maker
will be switched off automatically after 29 minutes
of nonoperation.
After pressing the button
(13) the coffee maker
will be switched off automatically after 29 minutes
of nonoperation.
DESCALING
For effective operation of the coffee maker we rec-
ommend to remove scale every month and more
often when you use “hard” water.
Regular descaling extends the coffee maker oper-
ating life and decreases the hazard of damaging
the unit.
IM VT-1525.indd 7 25.04.2016 15:17:59
Ваш отзыв будет первым