- Тип техники
- Бренд
Просмотр инструкции кофеварки Vitek VT-1522 BK, страница 7
7
E N G L I S H
– After the coffee maker operation is over,
switch it off by pressing the button (17) «
».
– Wait until the coffee maker cools down,
remove the filter holder (3) and wash the fil-
ter (27).
– If there is some milk left in the cappuccinator
(9), put the cappuccinator (9) into the fridge, if
you used all milk during making coffee, it is rec-
ommended to remove the cappuccinator (9)
and clean it (see the cappuccinator cleaning).
MAKING LATTE
Attention! When making latte be careful to avoid
burns by outgoing hot steam.
– Make sure that the removable tray (1) and the
tray grid (2) are installed to their places.
– Open the lid (7), lift the handle and remove the
water tank by the handle (pic. 1).
– Fill the tank with cold water not exceeding the
maximal level mark, place the tank back to its
place, lower the handle and close the lid (7).
– Press the cappuccinator release button (10)
and remove the cappuccinator (9).
– Press the milk container release button (12)
and remove the milk container (14) (pic. 2).
– Fill the container (14) with milk, do not exceed
the maximal level mark.
– Match the ledges on the cappuccinator (9)
with the grooves on the milk container (14),
install the container (14) on the cappuccina-
tor (9) until the release button (12) goes off.
– Install the cappuccinator (9) back to its place
until the release button (10) goes off.
– Insert one of the coffee filters (27) into the
holder (3).
– Add the required amount of ground coffee
into the filter (27) with a measuring spoon
(26) and slightly tamp the coffee in the fil-
ter (27) with the back side of the measuring
spoon (26).
– Install the filter holder (3) into the installation
place (5) and turn it to the right until bump-
ing (pic. 3).
– Place a cup of suitable height and capacity on
the tray grid (2) (see the table above).
– Turn the bar (15) to direct the cappuccinator
pipe (16) to the cup (pic. 4).
– Turn the frothed milk supply (intensity) con-
trol knob (11) to the left (in this position it pro-
duces more frothed milk).
– Insert the power plug into the mains socket.
– Switch the coffee maker on pressing the on/
off button «
» (17), you will hear a sound sig-
nal, and all the light indicators will light up and
flash on the control panel (8).
– When the coffee maker is ready for opera-
tion, you will hear sound signals, and the light
indicators on the con trol panel (8) will glow
constantly.
– Press the latte button (20) « », all the con-
trol buttons indicators will go out and the but-
ton (20) indicators will be flashing, after some
time the latte cappuccino making function will
be switched on.
Note:
– if you need to stop the latte making, press the
button (20) again.
– After the latte making is finished all the control
buttons indicators will light up.
– Remove the cup with the ready drink from the
grid (2).
– After the coffee maker operation is over,
switch it off by pressing the button (17) «
».
– Wait until the coffee maker cools down,
remove the filter holder (3) and wash the fil-
ter (27).
– If there is some milk left in the cappuccinator
(9), put the cappuccinator into the fridge, if you
used all milk during making coffee, it is recom-
mended to remove the cappuccinator (9) and
clean it (see the cappuccinator cleaning).
ATTENTION!
– If during making coffee the unit runs out of
water, a red light indicator (19) will light up
on the control panel (8) and you will hear
constant sound signals.
– Open the lid (7), add water to the tank and
press one of the buttons (18 or 25), after
the coffee making program is finished the
coffee maker will switch back to the ready
mode and all the light indicators will glow
constantly.
MAKING FROTHED MILK
You can make necessary amount of frothed milk
anytime. You can use the frothed milk for making
hot chocolate, macchiato, masala tea etc.
It is important that milk for making foam is fresh
and without additives, is not so-called long stor-
age milk.
Take usual whole milk with fat status from 4% to
6%, cream fat status should be not less than 10%.
– Prepare the coffee maker as described
above, it is not necessary to install the filter
holder (3).
IM VT-1522.indd 7 07.11.2017 12:06:28
Ваш отзыв будет первым