Бесплатные инструкции на русском языке
  • Тип техники
  • Бренд

Просмотр инструкции плиты Indesit K6G20 (R), страница 16

Indesit
16
c) Minimum regulation of the hob burners:
Turn the tap to minimum;
Remove the knob and adjust the regulation scre w, which
is positioned in or next to the tap pin, until the flame is
small b ut steady.
N.B.: In the case of liquid gas, the regulation scre w
must be scre wed in all the w a y.
Check that the flame does not go out when you turn the
tap quickly from high to lo w .
d) Regulating the primary air of the burners: The primary air
of the burners does not need to be regulated.
Adapting to diff erent types of gas
In order to adapt the oven to a different type of gas with
respect to the gas for which it was manufactured (indi-
cated on the label), f ollo w these simple steps:
a) Replacing the o v en burner nozzle
· open the o v en door fully
· pull out the sliding ov en bottom
· unscre w the burner fastening screws
V
· remo ve scre w V” and then the oven burner;
· Unscrew the oven burner nozzle using the special
sock et spanner for the nozzles, or a 7 mm socket span-
ner , and replace it with a nozzle suited to the new type
of gas (see Table 1).
T ake particular care handling the spark plug wires
and the thermocouple pipes.
· Replace all the parts, following the steps described
above in the re v erse order.
b) Regulating the minimum for the gas oven burner with
thermostat:
Light the burner as described in the paragraph “The Oven
Knob” in the instruction booklet;
urn the knob first to the Max setting for about 10 minutes
and then to Min;
Remove the knob;
Adjust the screw located outside the thermostat pin
until the flame is small but steady;
N.B.: In the case of liquid gas, the adjustment scre w
must be screw ed all the wa y in.
Check that the burner does not tur n off when you turn
the knob from Max to Min and when you open and close
the ov en door quickly.
Regulating the Primary Air for the Oven Burner
The oven burner do not need to be regulated in terms of
primary air .
Important
On completion of this operation, replace the old rating sticker
with one indicating the new type of gas used. This stick er is
a vailable from our Service Centres.
Note
Should the pressure of the gas used be different (or vary)
from the recommended pressure, it is necessary to fit a
suitable pressure regulator onto the inlet pipe in
compliance with current National Regulations relative to
“regulators f or channelled gas”.
Ваш отзыв будет первым
Задайте вопрос
Ваше имя
E-mail
Вопрос*
Ваш вопрос будет опубликован после проверки
Ваш вопрос опубликован
Посетитель_Dz33fx
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
Искать
Гость
07 февраля 2021, Нижний Новгород
не работает росжиг

Смотрите также другие инструкции раздела Плиты