- Тип техники
- Бренд
Просмотр инструкции плиты Indesit K6G20 (R), страница 14
14
Installation
The following instructions should be read by a qualified
technician to ensure that the appliance is installed, regu-
lated and serviced correctly in compliance with current
standards.
Important: Remember to unplug the appliance from
the mains before making adjustments or doing main-
tenance.
P ositioning
Important: This unit may be installed and used only in
permanently ventilated rooms in compliance with current
National Regulations. The following requirements must
be observed:
a) The room must be equipped with an exhaust system
that vents the comb ustion fumes to the outside. It may
consist of a hood or an electric fan that automatically
starts each time the appliance is turned on.
Flue or Branched Flue System Directly to the Outside
(only for cooking appliances)
b) The room must also have a system to permit proper
air circulation, needed for combustion to occur nor-
mally. The flow of air needed for comb ustion must not
be less than 2 m
3
/h per kW of installed power. The air
circulation system may take air directly from the out-
side by means of a pipe with an inner cross section of
at least 100 cm
2
; the opening must not be able to be
accidentally blocked. For those appliances not
equipped with a safety device f or accidental flame loss,
the v entilation apertures must be increased by 100%,
with the minim um being 200 cm
2
(Fig. A). The system
can also provide the air needed f or combustion b y in-
direct means, i.e. from adjacent rooms fitted with air
circulation tubes as described above. However , these
rooms must not be common rooms or bedrooms.
(Fig. B)
.
Detail A Adjacent Room to
Room be Ventilated
A
Examples of V entilation Openings Increased Opening Between
Comb urent Air Door and Floor
Fig. A Fig. B
c) Intensiv e and prolonged use of the appliance ma y re-
sult in the need for supplemental air circulation, e.g.
opening windows or increasing mechanical v enting (if
present).
d) Liquified petroleum gas is heavier than the air and,
theref ore, settles downw ards. Thus , rooms containing
LPG cylinders must also be equipped with aper tures
to the outside for v entilation of gas in the case of leaks.
LPG cylinders must not, therefore, be installed or stored
in rooms or storage areas that are belo w ground le vel
(cellars, etc.) whether the y are partially or completely
full. It is a good idea to keep only the cylinder being
used in the room, positioned so that it is not subject to
heat produced by external sources (ov ens, fireplaces,
stoves, etc. ) which are able to increase the tempera-
ture of the cylinder abov e 50°C.
Levelling Y our Appliance (only on certain models)
4 support feet which are adjusted using screws are located
in the lower part of the cooker. These level off the oven
when necessary. It is essential that the cooker be standing
level.
Mounting the legs (only on certain models)
Press-fit legs are supplied which fit under the base of your
cooker.
Installing the Cooker
The appliance can be installed ne xt to cabinets, provided
the y are not taller than the hob. If the cooker is placed in
contact with walls or the sides of adjacent cabinets , they
must be capable of withstanding a rise in temperature of
50°C above room temperature. For proper installation of
the cooker, the f ollowing precautions must be tak en:
a) Kitchen cabinets installed next to the cooker that are
higher than the top of the hob, must be at least 600
mm from the edge of the hob itself .
b) Hoods must be installed according to the requirements
in the installation manual f or the hood and, in any case,
at a minimum height of 650 mm.
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
Гость
07 февраля 2021, Нижний Новгород
не работает росжиг
0 ответов
Ответить
0