Просмотр инструкции квадроциклы Can Am DS 70 2011, страница 116
TROUBLESHOOTING GUIDELINES
ENGINE DOES NOT CRANK
1. Ignition switch is in the OFF position.
– Place switch to the ON position.
2. Burnt fuse.
– Check main supply fuse.
3. Weak battery or loose connections.
– Check connections and condition of terminals.
– Have the battery checked.
– Contact an authorized Can-Am dealer.
ENGINE TURNS OVER BUT FAILS TO START
1. Emergency engine stop switch is in the OFF position.
– Set switch to the ON position.
2. Mixture not rich enough to start cold engine.
– Checkfuel tank level and starting procedure for a cold engine, particularly use
of the choke.
3. Flooded engine (spark plug wet when removed).
– When the engine does not start after several attempts, the engine may be
flooded with fuel. Proceed as follows:
• Turn ignition switch to ON and ensure choke is not applied.
• Fully depress throttle lever and hold while starting the engine.
• As soon as the engine starts, release throttle lever. Do not race engine.
If the engine still does not start:
• Disconnect the spark plug cable.
• Remove the spark plug.
• Crank engine several times.
– Install new spark plug if possible or clean and dry removed spark plug.
• Start engine as explained above. If engine continues to flood, see an autho-
rized Can-Am dealer.
– Ensure there is no fuel in the engine oil due to engine flooding, if so, replace
engine oil.
4. No fuel to the engine (spark plug dry when removed).
– Check fuel tank level; turn fuel valve to ON (also try on RES.). A failure of the
fuel pump or carburetor may have occurred.
– Contact an authorized Can-Am dealer.
114
______________
Ваш отзыв будет первым