- Тип техники
- Бренд
Просмотр инструкции автомагнитолы Hyundai Electronics H-CDM8055, страница 6
6
Instal l ing the unit
Be sure you test all connections first, and then follow these steps to install the unit.
1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle
battery’s negative (-) terminal.
2. Disconnect the wire harness an d the anten na.
3. Press RELEASE button on the front panel and remove the front panel (see the steps of
“removi ng the front panel”).
4. Lift the top of the outer trim ring then pull it out to remove it.
5. Th e t wo suppl i ed ke ys rel ea se t abs i n si de th e un i t’s sl eeve s o you ca n r em ove it . In sert th e
keys as far as they will go (with the notches facing up) into the appropriate slots at the middle
left and right sides of the unit. Then slide the sleeve off the back of the unit.
6. Mount the sleeve by in ser ting th e sleeve in to th e openin g of the da sh board an d bend open
the tabs located around the sleeve with a screwdriver. Not all tabs will be able to make
contact, so examine which ones will be most effective. Bending open the appropriate tabs
beh in d the dashboard to secu re the sleeve in place.
7. Reconnect the wire harness and the antenna and be ca reful not to pinch any wires or cables.
8. Slide the unit into the sleeve until it locks into place.
9. To further secure the unit, use the supplied metal strap to secure the back of the unit in
place. Use the supplied h ardwar e (Hex Nut (M5mm) and Spring Washer) to atta ch one end of
the strap to the mounting bolt on the back of the unit. If necessary, bend the metal strap to fit
your vehicle’s mounting area. Then use th e supplied hardware (Tappin g Screw (5x25mm) and
Plain Washer) to attach the other end of metal strap to a solid metal part of the vehicle under
the dashboard. This strap also helps ensure proper electrical grounding of the unit. Note to
install the short threading terminal of the mounting bolt to the back of the unit and th e other
l ong threa ding termi nal to the dashboard.
10. Recon nect the ca ble to th e vehicl e batt ery’s n ega tive (- ) ter mina l. Th en r eplace th e out er
trim r ing an d install the unit’s front p anel (see the steps of “installing the fr ont panel”) .
Ваш отзыв будет первым