- Тип техники
- Бренд
Просмотр инструкции пылесоса Vitek VT-1886 B, страница 5
5
E N G L I S H
– there is no water in the aqua filter tank;
– not all filters are installed.
• Do not immerse the unit body into water or
other liquids.
• Clean the vacuum cleaner regularly.
• Close supervision is necessary when children
under 8 years of age or disabled persons are
near the operating unit.
• This unit is not intended for usage by children
under 8 years of age.
• This unit is not intended for usage by people
(including children over 8) with physical, neu-
ral and mental disorders or with insufficient
experience or knowledge. Such persons may
use this unit only if they are under supervision
of a person who is responsible for their safety
and if they are given all the necessary and
understandable instructions concerning the
safe usage of the unit and information about
danger that can be caused by its improper
usage.
• Do not leave children unattended to prevent
using the unit as a toy.
• For children safety reasons, do not leave
polyethylene bags used as packaging unat-
tended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger of
suffocation!
• To avoid damages, transport the unit in origi-
nal package only.
• Make sure regularly that the power cord and
the plug are not damaged. If the power cord
or plug is damaged or vacuum cleaner oper-
ates improperly, contact an authorized ser-
vice center.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
Safety measures
• Do not use the vacuum cleaner near hot sur-
faces, ashtrays and in places where inflam-
mable liquids are stored.
• Take sharp objects away from the floor before
cleaning to prevent unit damage.
• If the suction power of the vacuum cleaner
decreases rapidly while cleaning, switch it
off immediately and check the telescopic
pipe and the flexible hose for obstruction.
Switch the vacuum cleaner off, then unplug
it, remove the obstruction and only after that
continue cleaning.
ASSEMBLING THE VACUUM CLEANER
After unit transportation or storage under
cold (winter) conditions, it is necessary to
keep it for at least two hours at room tem-
perature before switching on.
Unpack the vacuum cleaner completely and
check it for damages. Do not use the unit in case
of damages.
Note:
– Before switching the unit on, make sure
that your home mains voltage corresponds
to the operating voltage of the vacuum
cleaner.
– Always switch the vacuum cleaner off and
unplug it while replacing the brush attach-
ments and before cleaning the dust bin (8).
Filling the aqua filter tank (11) with water.
• Remove the dust bin (8) by pressing the
release button (6) and pulling it by the handle
(7) (pic. 1).
• Open the locks (9), take the dust bin by the
carrying handle (7) and remove the dust bin
lid with the filter block (pic. 2).
• Fill the tank (11) with water up to the MAX
mark.
Note:
– The required water amount is approximately
500 ml.
• Install the dust bin lid with the filter block into
the tank (11). Make sure that it is installed
properly.
• Close the locks (9).
• Install the dust bin (8) to its place until the lock
(6) clicks.
ATTENTION!
• Do not exceed the “MAX” mark.
• Make sure that the dust bin lid and dust
bin (8) are installed properly on the vac-
uum cleaner body. To avoid damage of the
lid and dust bin (8) when installing them,
do not apply excessive effort.
Attaching flexible hose, telescopic pipe
and attachments
• Insert the flexible hose ending (12) into the air
inlet (10) until the release buttons (13) click
(pic. 3).
• To remove the flexible hose (14), press the
release buttons (13) of the ending (12) and
detach the hose (14).
• Insert the flexible hose handle (15) into the
telescopic extension pipe (16) (pic. 4).
VT-1886.indd 5 23.07.2014 11:42:57
Ваш отзыв будет первым