- Тип техники
- Бренд
Просмотр инструкции пылесоса Vitek VT-1833 PR/R/G, страница 6
6
ENGLISH
Small brush (15)
The brush is intended to collect dust from
the surface of the furniture, presence of pile
prevents polished surface of the furniture
from damages.
Crevice attachment (16)
The attachment is intended for cleaning of
radiators, crevices, corners and between
sofa pillows.
Attachment for furniture upholstery
cleaning (17)
Attachment is intended to clean fabric sur-
face of upholstered furniture.
Turbo-brush (18)
The turbo brush (18) can be used to clean
floors, rugs and carpets with long or short
pile, and is ideal for picking up animal fur.
The cylindrical brush with hard bristles ro-
tates under the action of the air current and
its bristles effectively remove animal fur and
loose carpet and rug fibers.
Note: Never use the turbo brush to clean
rugs with fringe and pile of 15 mm or more,
because the rotating brush can cause
damage to such rugs. Do not run the turbo
brush over power cords and turn off the
vacuum cleaner immediately after you are
done using it.
USAGE INSTRUCTIONS
Attention!
The vacuum cleaner with a water filter
is intended only for dry cleaning; do not
use the unit to pick up water or any oth-
er liquids.
Before using the vacuum cleaner, pull the
power cord out to the desired length and in-
sert the plug into an outlet. The yellow mark
on the power cord warns you when to stop
pulling. Never pull the power cord past the
red mark.
Attention!
Always turn on the vacuum cleaner only
with the installed dust-collecting bin
filled with water and with the installed fil-
ters (20, 21, 24). Always check whether
the filters are installed properly or not.
• To turn on the vacuum cleaner press the
On/Off button (3).
• During operation you can adjust suction
power using the suction control (2).
• After the cleaning is over, press the On/
Off button (3) and take the plug out of the
socket.
• Press the power cord-winding button (1),
and hold the winding cord with your hand
to prevent damage.
SERVICE
• When water in the bin (19) becomes dirty
(suction power can be reduced), you
should pour out it, to proceed with clean-
ing, fill the bin with clear water, refer to
the “Cleaning of the dust-collecting bin”
section.
Note: it is recommended that you empty
the dust collection bin and wash the bin
after each use.
• Before removal of the dust-collecting bin,
it is necessary to turn off the unit with the
switch (3), and then unplug the unit.
Cleaning of the dust-collecting bin
• Holding the handle (5) press the locking
button (4) and take the bin out of the vac-
uum cleaner (pic. 1).
• Open the latches (25) and remove the lid
of the bin (19).
• Pour out dirty water from the lower part of
the bin (26) and rinse it.
• Fill the lower part of the bin (26) with wa-
ter till the MAX mark.
Note: Necessary quantity of water -
600 ml.
• Put the lid (19) on the lower part of the bin
(26) and lock the latches (25).
• Put the dust-collecting bin on its place;
check that the bin is locked in the case of
the vacuum cleaner.
1833.indd 61833.indd 6 20.04.2009 9:32:1320.04.2009 9:32:13
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
саша
02 мая 2020, Алматы
можно ли мыть фильтр hepa?
0 ответов
Ответить
0