- Тип техники
- Бренд
Просмотр инструкции стиральной машины Zanussi FLS 1002 V, страница 19
ENGLISH
19
Whether discharging into a sink or a standpipe check that
the end of the drain hose is neither too high nor too low.
The top of the curve in the hose’s end should be no more
than 90 cm, and no less than 60 cm above floor level.
Should a prolongation of the drain hose be unavoidable
this must never surpass 1.5 m and must be of the same
diameter as the original hose
Important
Before connecting up the machine to new pipework or
to pipework that has not been used for some time, run
off a reasonable amount of water to flush out any debris
that may have collected in the pipes.
L evelling
Level the washing machine by loosening or tightening
the feet. Once in the right position fix the feet by
pushing the nuts against the base of the case
Accurate levelling prevents vibration, noise and
displacement of the machine during operation. After
levelling the machine, secure the feet by tightening the
ring nuts with the aid of a screwdriver.
Some vibration is inevitable, especially if mounted on a
wooden floor.
Sprung wooden floors are particularly susceptible to
vibration. For advice, consult a builder. If possible,
always place the machine on a solid floor.
Special condit ions
If the floor is carpeted with a deep-pile carpet or
covered with crumbly or soft material, insert a rigid
support base under the feet to prevent noise, vibration or
displacement. The base should protrude a few
centimetres beyond the edges of the machine.
Warning
The machine should NOT be placed on deep pile
carpeting.
Note
Please ensure that when the appliance is installed it is
easily accessible for the engineer in the event of a
breakdown.
P1039
Max. 90 cm.
Min.60 cm.
P0254
P0509
Ваш отзыв будет первым