- Тип техники
- Бренд
Просмотр инструкции швейной машинки Jaguar 745, страница 33
32
CHECK CHART FOR PERFORMANCE PROBLEMSCHECK CHART FOR PERFORMANCE PROBLEMS
CHECK CHART FOR PERFORMANCE PROBLEMSCHECK CHART FOR PERFORMANCE PROBLEMS
CHECK CHART FOR PERFORMANCE PROBLEMS
GENERAL PROBLEMSGENERAL PROBLEMS
GENERAL PROBLEMSGENERAL PROBLEMS
GENERAL PROBLEMS
Machine does not sew.
* Foot control is not connected.
-
See page 6.
* Power switch is turned off.
-
Turn on the switch.
Machine jams/knocks.
* Thread is caught in shuttle.
-
Clean shuttle (see page 31).
* Needle is damaged.
-
Replace needle (see page 10).
Fabric does not move.
* Presser foot is not lowered
-
lower presser foot.
* Stitch length is set at 0.
-
Set it at 1 to 4.
STITCHING PROBLEMSSTITCHING PROBLEMS
STITCHING PROBLEMSSTITCHING PROBLEMS
STITCHING PROBLEMS
Machine skips stitches.
* Needle is not all the way up into needle clamp.
-
See page 10.
* Needle is bent or blunt.
-
Replace needle (see page 10).
* Machine is not threaded correctly.
-
See page 11.
* Thread is caught in shuttle.
-
Clean shuttle (see page 31).
* Fabric is a certain knit or synthetic.
-
Use blue shank needle
(see page 10).
Stitches are irregular.
* Needle size is not correct for thread and fabric.
-
See page 10.
* Machine is not threaded correctly.
-
See page 11.
* Top thread tension is too loose.
-
See page 13.
* Fabric is being pulled or pushed against machine feeding action.
-
Guide it gently.
* Bobbin has not been wound evenly.
-
Rewind bobbin.
Needle breaks.
* Fabric is being pulled or pushed against machine feeding action.
-
Guide it gently.
* Needle size is not correct for thread and fabric.
-
See page 10.
* Needle is not all the way up into the needle clamp (See page 10).
THREAD PROBLEMSTHREAD PROBLEMS
THREAD PROBLEMSTHREAD PROBLEMS
THREAD PROBLEMS
Thread bunches.
* Top and bobbin threads are not drawn back under presser foot before
starting seam.
-
Draw both threads back under presser foot about 4
inches (10 cm) and hold until a few stitches are formed.
Needle thread breaks.
* Machine is not threaded correctly.
-
See page 11.
* Top thread tension is too tight.
-
See page 13.
* Needle is bent.
-
Replace needle (see page 10).
* Needle size is not correct for thread and fabric
-
See page 10.
Bobbin thread breaks.
* Bobbin case is not threaded correctly. See page 9.
* Lint accumulates in bobbin case or shuttle.
-
Remove lint
(see page 31).
Fabric puckers.
* Top and bobbin thread tensions are too tight.
-
Adjust thread tensions
(see page 13, 14).
* Stitch length is too long for sheer or soft fabric.
-
Shorten stitch length.
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
кристина
27 апреля 2024, Москва
Какая шпулька у этой машинки???
0 ответов
Ответить
0