- Тип техники
- Бренд
Просмотр инструкции блендера Vitek VT-1478 W, страница 7
7
ENGLISH
• Do not take off the attachment (6) during
operation of the blender.
• In order not to damage the blades, do not
process too hard products such as ice,
frozen products, grits, rice, seasoning
and coffee.
USING THE WHISK (PIC. 2)
Use the whisk attachment only to beat
cream, make biscuit dough or mix ready
deserts.
WARNING: before assembling make sure
that the power plug is not inserted into the
socket.
• Insert the whisk (8) into the gearbox (7).
• Insert the gearbox (7) into the motor unit
until clamping.
• Insert the plug into the socket.
• Put the whisk (8) into the bowl with prod-
ucts, use the control (1) to set the de-
sired speed 1-5, press and hold the but-
ton (2) during operation. While pressing
the button (3) the whisk will be rotating at
the maximal speed.
Attention!
Do not use the whisk (8) to knead stiff
dough.
Products should be put into the bowl
before switching on the unit.
Do not overfill the bowl.
Time of continuous operation of the
whisk should not be more than 2 min-
utes, after which wait 1 minute.
• After you stop using the unit, unplug the
unit, press the buttons (5) and remove
the whisk attachment. Disconnect the
whisk (8) from the gearbox (7).
• Do not take off the whisk attachment
during operation.
• Clean and wash all the details immedi-
ately after you stop operating the unit.
USING THE CHOPPER (PIC.3)
Chopper is used to chop meat, cheese, on-
ion, aromatic herbs, garlic, carrot, walnuts,
almond, and fruit.
Attention! Do not chop too hard prod-
ucts such as nutmegs, coffee beans
and cereals.
Before you start chopping:
• Cut meat, cheese, onion, garlic, car-
rot in (approximately equal) pieces.
• Remove stems from herbs, shell the
nuts.
• Remove bones, sinews and tendons
from meat.
• Remove the protecting cover from
the blade (10).
Chopping
Warning: Do not overfill the chopper bowl.
Be careful: the blades are very sharp!
Always hold the blade by the upper plastic
tip.
1. Put the blade (10) on the axis of the
chopper bowl (11) and turn it clockwise/
anticlockwise till clamping. Always use
the chopper bowl with the anti-slip sup-
port (12), which can be used as a cover
of the bowl (11).
2. Put the products into the chopper bowl
(11).
3. Set the gearbox-cover (9) on the bowl
(11) and turn it clockwise until clamp-
ing.
4. Insert the motor unit (4) into the gearbox
(9) until clamping.
5. Use the control (1) to set the required
speed 1-5. To switch on the chopper
press and hold the button (2). When
pressing the button (3) the chopper
blade will be rotating at the maximal
speed. During the operation hold the
motor unit (4) with your one hand, and
the chopper bowl (11) with the other
hand.
6. After you stop using the chopper, un-
plug the unit, press the buttons (5) and
1478.indd 7 01.12.2011 14:20:55
Ваш отзыв будет первым