- Тип техники
- Бренд
Просмотр инструкции блендера Vitek VT-8511 BK, страница 4
4
ENGLISH
is detected or after it was dropped, unplug
the unit and apply to any authorized service
center from the contact address list given in
the warranty certificate and on the website
www.vitek.ru.
• To avoid damages, transport the unit in the
original package only.
• Keep the unit out of reach of children and dis-
abled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, ITS COMMERCIAL USAGE AND USAGE
IN PRODUCTION AREAS AND WORK SPACES IS
PROHIBITED.
BEFORE USING THE UNIT
After unit transportation or storage at low
temperature, keep it for at least three hours
at room temperature before switching on.
• Unpack the unit completely and remove any
stickers that can prevent unit operation.
• Check the unit for damages; do not use it in
case of damages.
• Before switching the unit on, make sure that
your home mains voltage corresponds to the
unit operating voltage.
• Before the first use wash all removable parts
with warm water and neutral detergent and
then dry thoroughly.
• Clean the motor unit with a soft, slightly damp
cloth and then wipe it dry.
• Do not immerse the motor unit into any
liquids and do not wash it with water.
• Place the blender only on a flat steady surface.
ATTENTION! Continuous operation time of
the blender should not exceed 3 minutes;
then switch the unit off and let it cool down
to room temperature for at least 10 minutes.
• Do not remove the blender bowl and the bowl
lid during the operation.
USING THE BLENDER
• Install the blender bowl (3) on the motor unit
(5), to do this take the bowl (3) by the handle
with your right hand, install the bowl (3) on the
motor unit (5) and turn the bowl (3) counter-
clockwise until it is fixed.
• Put the necessary ingredients into the
bowl (3).
• Install the lid (2) into the bowl (3) and turn the
lid (2) counterclockwise until it is fixed.
• Insert the measuring cup (1) into the lid (2)
opening.
Notes:
– Before starting to chop/mix, we recommend
to peel fruit, remove inedible parts, such as
stones, and cut fruit into cubes approximately
2х2 cm in size.
– The blender is not intended for beating
eggs, making potato mash, kneading dough,
extracting fruit or vegetable juice, chopping
hard or frozen products, chopping meat and
meat products.
– The amount of foodstuffs to be processed
should not exceed 2/3 of the capacity of the
bowl in which they are processed or be below the
minimal «0,5» mark of the blender bowl.
– For easy control of the amount of the processed
food there are liquid scales on two sides of the
blender bowl.
• Make sure once again that the blender bowl
(3) is installed correctly and is fixed.
• Insert the power plug into the mains socket.
Note: The blender will not be switched on if the
blender bowl (3) is installed incorrectly.
• Use the operation mode switch (6) to set the
required rotation speed of the knives:
– «1» (low speed) – for mixing liquid prod-
ucts;
– «2» – mixing products.
– «3» – mixing and chopping.
– «4» (high speed) – for liquid and hard
products.
– «P» pulse mode
• To switch the pulse mode on, set the
switch (6) to the position «P» and hold it for
several seconds.
• During the operation or between the opera-
tion cycles, you can add the required ingre-
dients into the bowl (3). To do this, remove
the measuring cup (1) from the lid (2). After
adding ingredients through the lid (2) open-
ing, install the measuring cup (1) back to its
place. The capacity of the measuring cup (1)
is 60 ml.
• After the unit operation is finished, set the
operation mode switch (6) to the «0» position
and unplug the unit.
• Remove the blender bowl (3) from the motor
unit (5) by turning it clockwise.
• Remove the lid (2) from the bowl (3) turning
it clockwise.
• Take the processed products out of the
bowl (3).
• After the operation is finished, wash the
blender bowl (3).
IM VT-8511.indd 4 04.12.2017 14:22:19
Ваш отзыв будет первым