Бесплатные инструкции на русском языке
  • Тип техники
  • Бренд

Просмотр инструкции микроволновой печи Vitek VT-1686, страница 10

Vitek
10
ENGLISH
Eliminating malfunctions
Malfunction Possible causes Method of elimination
The oven will not
turn on
The power plug is not firmly
connected to the electrical outlet
Remove the power plug from the outlet. Wait 10
seconds and then replace
Problem with power outlet
Try plugging another electrical device into the
outlet to test it
The oven will not heat The door is not closed firmly Close the door firmly
When the oven
is operating, the
rotating glass tray
makes strange
noises
The roller ring or the cooking
chamber floor is dirty
Remove the glass tray and roller ring. Wash the
roller ring and the cooking chamber floor
Normal operation
The microwave oven creates static in
television and radio signals.
Static in television and radio signals can occur while the oven
is operating. Similar static is created by small electrical devices
like mixers, vacuum cleaners and electrical fans. This is a normal
occurrence.
The oven light is dim.
If the oven is set to a low power level, the light in the cooking
chamber may also be low. This is a normal occurrence.
Steam collects on the door and
hot air comes out of the ventilation
openings.
During the cooking process, steam is released from the food. Most of
the steam is released through the ventilation openings, but some can
collect on the inside of the door. This is a normal occurrence.
The microwave oven was turned on
without food inside.
Turning on the microwave oven for a short period of time while empty
will not cause any harm. Always make sure there is food in the oven
before starting it.
TECHNICAL CHARACTERISTICS
Operating Voltage: 220-240 V ~ 50 Hz
Nominal power output in microwave mode: 700 Wt
Operating frequency: 2450 MHz
Oven capacity: 17 liters
Glass tray: 245 mm diameter
The manufacturer reserves the right to change the device's characteristics without prior notice.
Service life - no less than 5 years.
GUARANTEE
Details regarding guarantee conditions can be obtained from the dealer from whom the appliance was purchased.
The bill of sale or receipt must be produced when making any claim under the terms of this guarantee.
This product conforms to the EMC-Requirements as laid down by the Council Directive 89/336/EEC
and to the Low Voltage Regulation (73/23 EEC)
Vt-1686.indd 10Vt-1686.indd 10 13.08.2009 14:36:4213.08.2009 14:36:42
Ваш отзыв будет первым
Задайте вопрос
Ваше имя
E-mail
Вопрос*
Ваш вопрос будет опубликован после проверки
Ваш вопрос опубликован