- Тип техники
- Бренд
Просмотр инструкции соковыжималки Vitek VT-3657 ST, страница 4
4
ENGLISH
aged, if the unit works improperly or after it
was dropped.
• Do not attempt to repair the unit. Do not disas-
semble the unit by yourself, if any malfunction is
detected or after it was dropped, unplug the unit
and apply to any authorized service center from
the contact address list given in the warranty
certificate and on the website www.vitek.ru.
• Transport the unit in the original package only.
• For environment protection do not discard the
unit with usual household waste after its ser-
vice life expiration; apply to a specialized cen-
ter for further recycling.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
BEFORE THE FIRST USE
After unit transportation or storage at low
temperature keep it for at least 3 hours at
room temperature before switching on.
• Unpack the juice extractor.
Disassemble and clean the juice extractor
before usage:
• Remove the pusher (1) from the lid (3) feed-
ing chute (2).
• Lower the lock (7) and remove the lid (3).
• For easy removal of the grating filter (4)
remove the grating filter with the juice collec-
tor (5) holding the juice collector (5) and pull-
ing it upwards.
• Wash thoroughly and dry all the removable
parts that will contact products.
Note: Be cautious when holding the grating fil-
ter (4) in your hands, as the disc grating surface
is very sharp.
MAKING JUICE
Before the first plugging in make sure that the
operating voltage of the unit corresponds to the
voltage of your mains.
Fruit and vegetables meant for processing must
be fresh.
Before juice extracting wash fruit/vegetables,
remove inedible parts from vegetables or fruit,
such as stems, hard peel or stones, for example,
of cherry or peach, cut them into pieces easily fit-
ting into the feeding chute (2).
• Place the motor unit (8) on a dry, flat and
steady surface.
• Before unit assembling make sure that the
operation mode switch is set to the position
«0», and the plug is not inserted into the mains
socket.
• Set the juice collector (5) on the motor unit
(8) (pic.1).
• Install the grating filter (4) into the juice col-
lector (5) (pic.1).
ATTENTION!
Do not use the juice extractor if you find
mechanical damages of the grating filter (4).
• Install the lid (3) on the juice collector (5) and
fix it with the lock (7) (pic. 2, 3).
• Set the pulp container (10) behind the juice
extractor (pic.3).
• Put a suitable container under the juice drain-
ing spout (6).
• Insert the power plug into the mains socket.
• Switch the juice extractor on by setting the
switch (9) to the position «I» (low speed), posi-
tion «II» (high speed) or position «P» (pulse
mode).
Notes:
Low speed «I» is intended for extracting juice
from soft vegetables/fruits, such as toma-
toes, ripe pears, strawberries, oranges, plums,
grapes, pumpkins, onions, cucumbers etc.
High speed «II» is intended for extracting juice
from hard vegetables/fruits, such as artichoke,
carrot, apples, capsicum, beet, potatoes, pine-
apples, vegetable marrows, celery, spinach, dill,
leek etc.
«Р» is pulse mode, switching the juice extractor
on for a short time.
ATTENTION!
To avoid the grating filter (4) stopping and
motor rotor jamming during the processing
of viscous or quite hard food it is recom-
mended to use the high speed operation
mode «II» of the juice extractor.
• The unit will be switched on only if all the
removable parts are installed properly, and
the lid (3) is fixed with the lock (7).
• Feed fruit/vegetable pieces into the lid (3)
feeding chute (2) only when the grating filter
(4) is rotating.
• Gradually put vegetables or fruits cut before-
hand into the lid (3) feeding chute (2) and
push them gently with the pusher (1). Do not
press on the pusher (1) too hard as it can lead
to decrease of juice amount as well as stop
the grating filter (4) rotation. The slower is the
fruit and vegetables processing, the higher is
the juice extraction rate.
IM VT-3657.indd 4 17.11.2016 10:56:50
Ваш отзыв будет первым