- Тип техники
- Бренд
Просмотр инструкции часов Vitek WX-4052 MS, страница 3
ENGLISH
3
ATTENTION!
The unit is not a toy! Do not allow
children to play with the unit.
Read the instruction manual carefully
before use. Use the unit only for its
intended purposes, as described in this
manual. Improper handling of the unit
can lead to its damage, do harm to the
user or its property.
This unit is not intended to be used
by children. Children can use the unit
ONLY under supervision of the person
responsible for their safety and only
after this person gave them complete
and clear instructions on safe use of the
unit and danger which can be caused by
its improper use.
CLOCK RADIO
CONTROLS AND FUNCTIONS
1. Power cord
2. FM antenna
3. SNOOZE button
4. Battery compartment
5. RUN/ALM/TIME Clock function selector
6. ON/AUTO/OFF Function selector
7. Lighted display
8. Rotating function dial
9. SLEEP button
10. Radio frequency tuning knob
11. AM/FM Band selector
12. VOLUME/BUZZER knob
13. Projector
14. Projector On/Off button
15. Minute setting button for projector
16. Hour setting button for projector
17. Projector focus control
18. Time setting button for projector
POWER
1. Connect the power cord to the outlet.
Make sure that the voltage indicated on the
device matches the voltage in your home.
2. Place one 9 V battery (not included) into
the battery compartment (4). The bat-
tery maintains the clock in case of power
failure. In such cases, the display will not
work, but the time is being maintained.
RADIO
1. Set the ON/AUTO/OFF (6) selector to the
ON position.
2. Set the desired band using the band selec-
tor (11).
3. Tune to the desired radio station using the
tuning knob (10).
4. Adjust the volume by turning the knob
(12).
5. Extend the antenna wire (2) fully for best
reception of FM-band signals.
6. Set the selector (6) to the OFF position to
turn the radio off.
SETTING THE CURRENT TIME
In order to set the current time, move the
RUN/ALM/TIME (5) selector to the TIME po-
sition and turn the dial (8) to the left (to set
the minutes) or to the right (to set the hours).
When the time has been set, move the RUN/
ALM/TIME (5) selector back to RUN. The two
blinking dots on the display (7) should stop
blinking.
SETTING THE CURRENT TIME FOR THE
PROJECTOR
Attention! The current time shown on the dis-
play and that projected by the projector must
be set separately.
Projector:
Set the projector selector (14) to the ON posi-
tion. Press and hold the T button (18); press
the H (16) button to set the hours and the M
(15) button to set the minutes. Switch the pro-
jector selector (14) to the OFF position to turn
the projector off.
Note: The time displayed by the projector on
the wall or ceiling can be easily seen in a dark
room. The maximum projection distance is
0.6 – 2.7 m. Use the focus control dial (17)
to adjust the brightness and focus of the pro-
jected image.
SETTING THE ALARM TIME
In order to set the current time, move the
RUN/ALM/TIME (5) selector to the ALARM
position and turn the dial (8) to the left (to set
the minutes) or to the right (to set the hours).
4052_MS.indd 34052_MS.indd 3 20.09.2011 13:12:0420.09.2011 13:12:04
Ваш отзыв будет первым