Бесплатные инструкции на русском языке
  • Тип техники
  • Бренд

Просмотр инструкции пылесоса Vitek VT-8105 VT, страница 5

Vitek
5
E N G L I S H
Dust bin (11)
The dust bin (11) is equipped with the cyclonic fil-
ter (24) which eliminates garbage and dust from
the air, and the HEPA (25) filters retain the finest
dust particles.
Note:
provide that the HEPA filter (25) is always
clean, because the overall performance of
the vacuum cleaner depends on it;
the dust bin (11) compartment is equipped
with the blocking device preventing the dust
bin (11) installation without the HEPA fil-
ter (25). Always make sure that the HEPA fil-
ter (25) is installed properly before setting the
dust bin (11) back to its place.
OPERATION
Safety measures
Do not use the vacuum cleaner near hot sur-
faces, such as ashtrays and in places where
inflammable liquids are stored.
Take sharp objects away from the floor before
cleaning to prevent unit damage.
If the suction power of the vacuum cleaner
decreases rapidly while cleaning, switch it off
immediately and check the telescopic pipe
(4) and the flexible hose (7) for obstruction.
Switch the vacuum cleaner off, then unplug
it, remove the obstruction and only after that
continue cleaning.
USING THE VACUUM CLEANER
ATTENTION! You may switch the vacuum cleaner
on only with the dust bin (11) installed with the
HEPA filter (25) installed in the dust bin, and with
the outlet HEPA filter (21) installed. Always make
sure that the filters (21, 24, 25) are installed prop-
erly.
Before using the unit, unwind the power cord
to the required length and insert the power
plug into the mains socket.
The yellow mark on the power cord indicates
the maximum cord length. Do not unwind the
power cord further than the red mark.
Press the on/off button (18) to switch the vac-
uum cleaner on.
During the operation you can control the suc-
tion power using the power control (16) and
the manual suction power control (5) on the
flexible hose handle (6). After room clean-
ing switch the vacuum cleaner off by press-
ing the on/off button (18) and unplug the
unit.
To wind the power cord, press the button (15),
hold the winding cord with your hand to avoid
its whipping and damage.
During the breaks you can place the brush (1)
in the brush storage (17).
CLEANING AND CARE
Cleaning the dust bin (11)
Remove garbage and dust from the dust bin (11)
after every room cleaning.
Switch the vacuum cleaner off and unplug it.
Holding the handle (12), press the lock (13)
and remove the dust bin (11) from the vacuum
cleaner body pulling upwards (pic. 1).
Hold the dust bin (11) by the handle (12), take
the lid (23) by its rear part with your other
hand and remove it from the dust bin (11)
(pic. 2).
Turn the dust bin (11) upside down and
remove dust and garbage from it (pic. 3).
Set the lid (23) back to its place, first insert
the front part of the lid and then lower the rear
part until the clamp (22) clicks.
Install the dust bin (11) back to its place.
Cleaning the filters (24, 25) installed
in the dust bin (11)
Preliminarily remove dust and garbage from
the dust bin (11) as described above.
Remove the HEPA filter (25).
Remove the cyclonic filter (24) having prelimi-
nary removed the dust bin lid (23).
To remove the cyclonic filter (24) remove the
filter (24) from the installation place by pull-
ing it upwards.
To remove the cyclonic filter (24), turn it coun-
terclockwise and remove the filter (24) from
the installation place (pic. 4).
Clean the filters from dust and garbage, wash
the cyclonic filter (24) and the HEPA (25) filter
under warm water jet.
Note:
wash the HEPA filter (25), directing the water
jet to the outer side of the HEPA filter (25).
Do not wash filters in a dishwashing machine.
Dry the filters thoroughly.
Do not dry the HEPA filter (25) with a hairdryer.
Wash the dust bin (11), wipe it and dry.
Install the cyclonic filter (24) to the installation
place and then close the lid (23).
Install the HEPA filter (25) back to its place.
Install the assembled dust bin (11) back to
its place.
IM VT-8105.indd 5 22.08.2017 11:40:08
Ваш отзыв будет первым
Задайте вопрос
Ваше имя
E-mail
Вопрос*
Ваш вопрос будет опубликован после проверки
Ваш вопрос опубликован