- Тип техники
- Бренд
Просмотр инструкции вентилятора Vitek VT-1934, страница 6
6
ENGLISH
• To stop the rotation mode pull the button (8)
upwards.
• Consequently press the button (17) “ ” to
select the air flow mode. You may choose
three operation modes, the operation modes
are shown as the icons (20, 18, 24):
– « » – ventilation, the icon (20) is glowing;
the blades rotation speed depends on the
selected mode and is shown with the indi-
cators (19, 25, 23) «L, M, H».
– « » – natural wind, the icon (18) is glow-
ing; natural wind imitation mode, the air
flow speed is chaotically changing: from
soft breeze to strong gusts of wind.
– « » –night mode, the icon (24) is glowing;
the air flow speed is changing in cycles,
constantly increasing and decreasing.
• Automatic switch-off timer operation time is
selected by the button (26) “
”, the icon (22)
will be glowing, the digital symbols (21) will
indicate the remaining fan operation time
before its switching off.
• You can set the fan operation time from 1 «1 h»
hour to 9 «9h» hours (with 1 hour setting step).
• To check the switch-off timer operation time
press the button (26) “
”, the remaining time
before switching off will be shown in 5 sec-
onds with the flashing digital symbols (21),
the room temperature will be indicated with
the symbols (21).
• To switch the timer off consequently press the
button (26) “
” until the digital symbols (21)
show the time «0h».
• To switch the fan off, press the button (10)
“
”.
• You may change the position of the motor unit
(7) of the fan in accordance with the required
air flow angle in the vertical position, the fan
slope angle is set manually. To change the
fan slope angle press with a slight effort on
the motor unit (7) upwards or downwards.
Clicking while the fan is being tilted is normal.
USING THE REMOTE CONTROL (27)
ATTENTION!
Batteries leakage can cause injuries or the
unit damage. To avoid the unit damage, fol-
low the instructions given below:
– use only the “AAA” batteries;
– do not use old and new batteries at the same
time or different types of batteries;
– do not recharge the batteries;
– insert the batteries strictly following the
polarity;
– remove the batteries if you are not planning to
use the unit for a long time;
– replace the batteries in time.
– apply to specialized centers for further recy-
cling of the batteries;
– avoid the power nippers circuit.
To use the remote control (RC) (27) open the bat-
tery compartment lid (28) and insert 2 “AAA” bat-
teries (not supplied with the unit) into the battery
compartment strictly following the polarity, close
the battery compartment lid (28). If you do not
use the unit for a long time, remove the batter-
ies from the battery compartment of the remote
control (27).
Note: – the buttons on the remote control (27)
fully correspond with the buttons on the control
panel (9).
MAINTENANCE AND CARE
• Before cleaning the fan switch it off by press-
ing the button (10) “
” or the button (10)
“
” on the remote control (27) and unplug it.
• Do not use abrasive cleaners and solvents to
clean the unit.
• Clean the motor unit (7) with a slightly damp
cloth, and then wipe it dry.
• If you need to clean the blades (4), unscrew
the nut on the ring (2), remove the ring (2),
remove the front grid (1), and then wipe the
blades with a slightly damp cloth.
• Install the front grid (1) and the ring (2) back
to its place.
• You may clean the fan blades with a vacuum
cleaner using a proper attachment.
• Do not immerse the motor unit (7) of the fan
into water or any other liquids. Make sure that
no liquids get into the motor unit (7) of the fan
to avoid its damage and prevent risk of elec-
tric shock.
STORAGE
– Unplug the fan and clean it.
– If necessary, disassemble the fan.
– Remove the ring (2), the front grid (1),
unscrew the blade clamp (3) by turning it
clockwise, remove the blades (4), unscrew
the fixing nut of the rear grid (5) and remove
the grid (6).
– Unscrew the clamp (11) and remove the motor
unit (7) from the telescopic bar (12).
IM VT-1934_2.indd 6 03.12.2018 16:13:52
Ваш отзыв будет первым