Бесплатные инструкции на русском языке
  • Тип техники
  • Бренд

Просмотр инструкции утюга Saturn ST-CC7130, страница 6

Saturn
10
6. Install the steam head to superior tube hooking.
Filling the water fill tank
1. Unplug the power cord, and turn the lighted ON/OFF switch to the OFF”
position.
2. Remove the water fill tank; turn it upside down, and unscrew the valve cap.
3. Fill the water fill tank with cool water, and replace the valve cap.
NOTE: To prolong the lifetime of your steamer, we recommend using distilled
or de-mineralized water.
NOTE: Do not substitute another water tank for the one designed for this unit.
4. Place the water fill tank on the water reservoir. You should hear water flowing
into the water reservoir for a short time.
CAUTION: Do not let the steamer operate with a dry water fill tank, or damage
to the unit could occur.
Quick Storage
1. Turn the ON/OFF switch to “OFF”.
2. Unplug the power cord.
3. Wrap the hose around the telescopic pole one time.
4. Hang the steam nozzle from the steam nozzle holder.
5. Loosen the three fasteners on the telescopic pole
6. Push down on the pole top; the pole will collapse to a compact height.
7. Roll the unit to a convenient storage location.
11
Cleaning and Long-term Storage
We recommend you follow this procedure at least once per week. Use of distilled or
de-mineralized water reduces the need to clean an prolongs the life of your steam
1. Turn the lighted ON/OFF switch toOFF”.
2. Unplug the unit from the power outlet.
3. Wait for the unit to cool completely (at least 30 minutes).
4. Remove the hose and the telescopic pole and set them aside.
5. Carry the unit to a sink or tub.
6. Remove and drain the water fill tank. Rinse the water tank with fresh water and
drain completely.
7. Flush the unit by filling the water reservoir and the hose base with fresh water and
draining completely.
8. Place the water fill tank bank on the water reservoir.
9. Reattach the telescopic pole and hose.
10. Follow steps 3-6 of the quick storage procedure above.
Troubleshooting
Problem Cause Solution
The security device does
not work.
One of the circuits has fault,
the plug is loose, the fuse
burned, the LED of supply
source is extinguished.
Check and maintain by
specialized technician
A noise originates pipe
of steam but the
produced steam is weak.
The pipe is twisted below
level to iron.
Raise the steam pipe
(residual water in top
returns into the device).
Spray head is leaked The head is broken, or the
ironing is vertical.
Replace the spray head.
Move from top down to
operate.
Hooking connection of
steam pipe is leaked.
The cushion can be damaged
itself with the aging, the
junction interface loosen
Replace the cushion.
Rotate the junction of
steam pipe tightly.
Ваш отзыв будет первым
Задайте вопрос
Ваше имя
E-mail
Вопрос*
Ваш вопрос будет опубликован после проверки
Ваш вопрос опубликован