- Тип техники
- Бренд
Просмотр инструкции утюга Saturn ST-CC7141, страница 3
4
· No liability can be accepted for any
damage caused by noncompliance with
these instructions or any other improper
use or mishandling.
· The iron should always be turned to
"min" before plugging or unplugging
from the mains outlet. Never pull the
cord to disconnect from the mains:
instead, grasp plug and pull to
disconnect.
· Burns can occur from touching hot
metal parts, hot water or steam, use
caution when you turn a steam iron
upside down-there may be hot water in
the reservoir.
· If the iron is not operating normally,
disconnect from the power supply and
contact the nearest authorized service
agent.
· Your iron is designed to rest on the
heel. Do not leave the iron unattended
when switched on. Do not place the iron
on an unprotected surface even if it is
on its heel rest.
FILLING WITH WATER
· Ensure the iron is disconnected
from the power supply.
· Turn the steam control knob to
position "0".
· Fill with water through water filling
inlet. (Do not exceed main level mark
on the water tank.)
SETTING THE TEMPERATURE
* Synthetics-Silk
** Wool
*** Cotton- Linen
· Stand the iron upright.
· Set temperature control to ironing
temperature.
· Inset the mains plug into the main
supply.
· After the indicator light has gone
out and come on again, you may start
ironing.
· The indicator light will go out from
time to time during ironing.
STEAM-IRONNING
· Set the temperature control to
position** for moderate steam and to
*** for maximum steam. With
conventional steam irons, water may
leak from the soleplate if a too low
temperature has been selected.
· Ensure that there is enough water
in the water reservoir.
· Stand the iron on its heel.
· Insert the mains plug into the wall
socket.
· Wait a little while for the indicator
light to go out and come on again.
· See the variable steam knob to
adjust the steam.
BURST OF STEAM
· By pressing button an intense
"Burst "of steam is emitted from the
soleplate.
· To prevent water leaking from the
sole plate, do not keep the steam
control button depressed for more than
5 seconds.
SPRAY SETTING
· At any temperature by pressing the
spray button a couple of time the
laundry can be damped down.
· Ensure that there is enough water
in the water reservoir.
DRY IRONING
· Turn the variable steam knob to the
position "O"(=no steam).
STORAGE
· Remove the mains plug from the
wall socket.
· Pour and remaining water out of the
water reservoir.
· Set the steam knob to no steam
position.
· Stand the iron upright and let it
coot down sufficiently.
CLEANING
· Before cleaning the iron ensure it is
disconnected from the power supply and
has completely cooled down.
· Deposits on the soleplate may be
removed with a rough cloth soaked in a
vinegar/water solution.
· The casting may be wiped with a
damp cloth and then polished with a dry
one.
· Do not use abrasives on the
soleplate.
· Keep the sole plate smooth. Avoid
hard contact with metal objects.
SELF CLEANING
It is important to apply "self-cleaning"
at least every two weeks to remove
impurities etc.
· The harder the water the more the
iron should be self-cleaned.
· Open the filling funnel and fill the
water reservoir up to the MAX position,
then close the filling funnel.
· Set the temperature control to
MAX.
· Insert the mains plug into the wall
socket.
· Allow the iron to heat up until the
temperature pilot light goes out.
· Then set temperature control dial to
position MIN.
· Hold the iron horizontally over the
sink, then remove the variable steam
control knob from the body enabling the
5
iron to self clean.
· Boiling water and steam will now be
ejected from the holes in soleplate.
Impurities are washed away with it.
Move the iron forwards and backwards
while this happened.
· Set the steam control to "O"
position, when the water reservoir has
become empty.
· Repeat self-cleaning if you notice
that much impurity or other has been
washed out.
· Move the iron over a (preferably)
old piece of cloth. This is to ensure that
the soleplate will be dry during storage.
· Unplug and allow the iron to cool
clown before storing it.
Specification
Power: 2000 W
Rated Voltage: 220-230 V
Rated Frequency: 50 Hz
Rated Current: 9 A
Set
Iron 1pc
Instruction Manual 1pc
Warranty Book 1pc
Package 1pc
ENVIRONMENT FRIENDLY
DISPOSAL
You can help protect the
environment!
Please remember to
respect the local
regulations: hand in the
non-working electrical
equipments to an
appropriate waste disposal
centre.
The manufacturer reserves the right
to change the specification and
design of goods.
RU
УТЮГ
Уважаемый покупатель!
Поздравляем Вас с приобретением
изделия торговой марки “Saturn”.
Уверены, что наши изделия будут
верными и надежными
помощниками в Вашем домашнем
хозяйстве.
Не подвергайте устройство резким
перепадам температур. Резкая
смена температуры (например,
внесение устройства с мороза в
теплое помещение) может
вызвать конденсацию влаги
внутри устройства и нарушить его
работоспособность при
включении. Устройство должно
отстояться в теплом помещении не
менее 1,5 часов. Ввод устройства в
эксплуатацию после
транспортировки производить не
ранее, чем через 1,5 часа после
внесения его в помещение.
Описание:
1. Кнопка распыления воды
2. Кнопка усиленной подачи пара
3. Регулятор степени отпаривания
4. Окошко для наполнения воды
5. Распылитель воды
6. Декоративная вставка
7. Подошва утюга
8. Регулятор температурного режима
9. Прозрачный резервуар для воды
10. Индикатор работы
Ваш отзыв будет первым