- Тип техники
- Бренд
Просмотр инструкции машинки для стрижки Saturn ST-HC7383, страница 4
6
STEP 3 - SIDE OF THE HEAD
Change to one of two shorter combs
3mm or 6mm, trim sideburns, i.e. the
hair directly in front of the ears. Then
change to one of the longer combs
9mm or 12mm, and continue to cut to
the top of the head (see diagram 3).
STEP 4 - TOP OF THE HEAD
1. Using comb attachment 9mm or
12mm, cut top of head from back to
front against the direction, in which
the hair normally grows (see diagram
4). ln some cases, this may require
the reverse, or cutting from front to
back.
2. Comb attachments 3mm or 6mm
are used to achieve a close crew cut
or short cut.
3. For longer hair on top, use the
comb provided and lift hair on the top
of the head. Cut over the comb, with
the hair lifted or hold the hair between
the fingers to lift it and cut it to
desired length (see diagrams 5 and 6).
Always work from the back of the
head. You can cut the hair shorter
gradually by reducing the space
between the comb/fingers and the
head. Comb out trimmed hair and
check for uneven strands.
STEP 5 - THE FINISHING TOUCH
1. Finally, use the taper lever
without an attachment comb for close
trimming around the base of the neck,
the sides of the neck and the ears.
2. Press the clipper at right angles to
the head, tips of the blades lightly
touching the skin and work
downwards. This way you will obtain a
clean cut, as would be given by a
razor.
SHORT TAPERED STYLES - 'FLAT
TOPS' AND SHORT CUTS
1. Starting with the longest
attachment comb (12mm), cut from
the back of the neck to the crown.
Hold the attachment comb flat against
7
the head and slowly move the clipper
through the hair, as shown (see
diagram 8).
2. Use the same procedure from the
lower side to the upper side of the
head, as illustrated. Then cut the hair
against the direction, in which it
grows, from the front to the crown
and then level the cut with the sides.
3. To give a flat top look, the hair on
top of the head must be cut over the
top of a flat comb rather than by using
the attachment comb.
4. Use closer cutting attachment
combs to taper the hair down to the
neckline as desired. Comb hair and
check for uneven areas and outlining
sideburns and neckline, as described
previously.
Technical Data:
Power: 15 W
Rated Voltage: 220-230 V
Rated Frequency: 50 Hz
Rated Current: 0.07 А
Accessories: 4 attached
combs, clean brush, scissors, hair
comb, oil
Set
HAIR CLIPPER…….…………1
INSTRUCTION MANUALWITH
WARRANTY BOOK…………1
PACKAGE….……………………1
ENVIRONMENT
FRIENDLY
DISPOSAL
You can help
protect the
environment!
Please remember to
respect the local
regulations: hand in
the non-working
electrical equipment
to an appropriate
waste disposal center.
The manufacturer reserves the
right to change the specification
and design of goods.
RU
МАШИНКА ДЛЯ СТРИЖКИ
Уважаемый покупатель!
Поздравляем Вас с
приобретением изделия
торговой марки “Saturn”.
Уверены, что наши изделия
будут верными и надежными
помощниками в Вашем
домашнем хозяйстве.
Не подвергайте устройство
резким перепадам температур.
Резкая смена температуры
(например, внесение устройства
с мороза в теплое помещение)
может вызвать конденсацию
влаги внутри устройства и
нарушить его работоспособность
при включении. Устройство
должно отстояться в теплом
помещении не менее 1,5 часов.
Ввод устройства в эксплуатацию
после транспортировки
производить не ранее, чем через
1,5 часа после внесения его в
помещение.
ПРОЧИТАЙТЕ ВСЮ ИНСТРУКЦИЮ
ПО ЭКСПЛУАТАЦИИ ПЕРЕД
ИСПОЛЬЗОВАНИЕМ И
СОХРАНИТЕ ЕЕ НА БУДУЩЕЕ
Ваш отзыв будет первым