- Тип техники
- Бренд
Просмотр инструкции конвектора Saturn ST-HT8663, страница 2
GB
CONVECTION HEATER
Dear Buyer!
We congratulate you on having
bought the device under trade
name “Saturn”. We are sure that
our devices will become faithful
and reliable assistance in your
housekeeping.
Avoid extreme temperature
changes. Rapid temperature
change (e.g. when the unit is
moved from freezing temperature
to a warm room) may cause con-
densation inside the unit and a
malfunction when it is switched
on. In this case leave the unit at
room temperature for at least 1.5
hours before switching it on.
If the unit has been in transit,
leave it indoors for at least 1.5
hours before starting operation.
Please read the manual carefully
prior to use.
Product structure
Note:
1. The product can not be placed di-
rectly below a fixed socket, because
the product coverage or incorrect
placement can cause a fire. It can not
be used with the program, timers, or
any other device. If the power cord is
damaged, we must use our local deal-
er or service center to provide a dedi-
cated power line to be replaced. Power
cord and plug must be able to with-
stand more than 10A of load, and be a
reliable ground!
2. When in use must not be placed in
the bed or flammable, explosive and
other gases environment! Best on the
floor or hung on the wall, between the
heater and combustibles for at least
80 cm above the distance! !
3. In the course of an abnormality is
found, shall be promptly disconnect
the power, do not disassemble, and
notify the company in the local dealer
or our service department for mainte-
nance.
4. In the course do not frequent the
control switch on or off when not in
use, disconnect the power cord un-
plugged!
5. In use, is strictly prohibited in the
outlet or any object covered with
sticks and other foreign matter into
the protective cover to prevent acci-
dents!
6. During use, the elderly, children or
persons with mobility problems should
be under the guidance of his family's
care or use.
7. Service life - 4 years.
Installation:
1. Open the packaging, remove the
product, verify that the product in
good condition.
2. Use a screwdriver to remove the
link back of the product, installed in
the following table according to size of
the hooks on the wall.
Usage:
1. Before the use of the convection
heater make sure that the data of the
device corresponds the data of your
mains.
2. Plug the power cord into the socket.
3. Make the thermostat on the control
panel to maximum.
4. You can set the power knob for
heating at the modes I or II.
5 This convection heater is equipped
3
with the 2 hours timer.
6. If the heating reached your desired
temperature, turn temperature control
knob counterclockwise until you hear
the sound, and the convection heater
will stop working.
7. In the course of the convection
heater will automatically maintain the
temperature you set. When the room
temperature reaches the temperature
you set, the convection heater will
automatically stop working. When the
indoor temperature is lower than the
temperature you set, the convection
heater will automatically open the
work in cycles, in order to maintain
the best indoor temperature.
Ваш отзыв будет первым