Просмотр инструкции пылесоса Saturn ST-VC7295, страница 3
4
Do not the appliance to vacuum lighted
matches, cigarette ends or hot ash.
Do not use the appliance on wet surface.
Do not use the appliance when it upright.
Do not use appliance to vacuum needles,
drawing-pins or sting.
ASSEMBLING THE VACUUM CLEANER
Always remove the plug from the power
socket before Fitting or removing accesso-
ries.
Fitting the flexible tube
Insert the flexible tube into the air intake
duct on the appliance. To do this, slide The
intake duct cover insert the tube and press
until it clicks into position.
Removing the flexible tube
Remove the plug from the power socket. To
release the flexible tube, press the Button
on the end of the tube firmly the air intake
duct.
Fitting the extension tubes and acces-
sories
Removing the extension tubes and ac-
cessories
To remove the accessories, pull firmly
apart.
INSTRUCTION FOR USE
1. Before using the appliance, unwind
length of cable and insert the plug into the
power socket, A YELLOW mark on the pow-
er cable shows the ideal cable length, Do
not extend the cable beyond the Red mark,
To rewind the power cable, press the re-
wind button witch on hand, and guide the
other hand to ensure that it does not whip
causing damage, If the power cable can’t
rewined completely. Please pull out the
power cable a little bit and press the re-
winder button again. You can repeat the
rewinding steps until the cable is rewinded
completely.
5
2. Press the ON/OFF button to switch the
appliance on. It is advisable to set the elec-
tronic power regulator to MIN before
switching the appliance on.
3. By turning the speed control knob the
absorption power can be adjusted.
HOW TO CLEAN THE DUST CABIN
1 Press the locking block to open the front
cover.
2. Pull out the dust bag by holding the card.
Put back a new or clean bag.
3. Paper dust bag can't be reused; cloth
bag can be reused after cleaning.
Attention: the opening of the cloth bag
must be completely closed by the clip.
4. Close the cover.
MAINTENANCE
When the motor filter is dirty remove the
filter and wash carefully in liquid or water.
Allow the filter to dry completely before
replacing it.
1. To clean or replace the air outlet
filter, first detach the grille by pull-
ing firmly away from the appli-
ance.
2. Remove the filter from the appli-
ance. Clean or replace the filter.
The filter should be washed regular
under the tap and allowed to dry
before replacing it in the filter
grille.
3. Re pace the filter every 2-3
months, depending on how for
quantity is used.
USING THE CLEANING ACCESSORIES
Dual-position carpet/floor brush
Pos.1:bristles extended, for hard floors
Pos.2: bristles shrinked, for carpets:
Narrow nozzle
For cleaning radiators, comers, edges
drawers etc,
Small brush
For cleaning curtains, shelves, books, lamps
and other delicate objects.
Ваш отзыв будет первым