Просмотр инструкции стиральной машины Saturn ST-WM0622, страница 5
8
· Keep the transit bolts for future transportation. Whenever the machine is transported,
the transit bolts must be refitted.
Installation place requirement
· A concrete floor is the most suitable installation
surface for a washing machine, being far less
prone to vibration during the spin cycle than
wooden floorboards or a carpeted surface.
· The machine must be level and securely
positioned. The distance between the machine and
wall must be more than 10 cm.
· To avoid vibrations during spinning, the machine
should not be installed on soft floor coverings.
Level adjustment
The machine must stand perfectly level
on all four feet to ensure safe and proper
operation.
Incorrect installation may increase
electricity and water consumption and
may cause the machine to move about.
To do these when the machine is not
level:
· Using the spanner, turn locknut in a
clockwise direction. Then turn
locknuts together with adjust feet to
unscrew.
· Use a spirit level to check the
machine is standing level.
· Hold adjust feet securely with a pipe
wrench. Turn locknut again using the
spanner, until it sits firmly up against
the housing.
Note
Vibration and noise may occur, if the locknuts do not sit firmly
up against the houses.
Drain hose connection
1. Direct into a sink
If the outlet spigot has not been used before, remove any blanking plug that may be in
place.
9
Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is
formed in the drain hose to prevent waste from the sink enter the washing machine.
If required, the drain hose can be extended to a length of 4 m.
2. Connected securely to a standpipe
Firstly form a hook in the end of the drain hose using the “U” piece supplied.
Place the drain hose into your standpipe, which should have an internal diameter of
approximately 38 mm, thus ensuring there is an air break between the drain hose and
standpipe.
When discharging into a standpipe ensure, that the top of the standpipe is no more than
90 cm and no less than 60 cm above floor level.
Water inlet connection
Connect the inlet hose supplied with the machine to a tap with a 3/4” thread.
Do not use previously employed hoses.
Installation should comply with local water authority and building regulations’
requirements.
When there is an inlet valve at the back of the machine, it must be connected to a cold
water supply. Follow the indication of the picture below to complete the connection.
Ваш отзыв будет первым