- Тип техники
- Бренд
Просмотр инструкции автосигнализации Mongoose AMG-850C, страница 7
7
English
Passive arm.
This function can be enabled or disabled by programming at set-up.
If the feature is enabled, then turning off the ignition, opening or closing the door, will
cause two flashes of the signal lights and the LED will blink fast. If 30 seconds later all
doors, the hood and the trunk remain closed, the alarm system will be armed and the
doors will lock.
If the Passive arm feature is used, the alarm delay mode is activated, which allows you
to take your seat in the car and disarm the system with a PIN code - there will be no
alarm for 10 seconds. Delay duration of up to 20 seconds can be set by programming.
Automatic door lock at ignition turn-on.
The electrical door locks automatically lock 10 sec after ignition switch-on, once the
ignition is switched off, the locks will unlock. If any door happens to be open within these
10 sec, there will be no automatic locking to avoid locking in the keys. The function can
be disabled by programming.
Remote control of central lock.
With the ignition on, the door locks can be locked or unlocked at any moment by
pressing the transmitter buttons 1 or 2 respectively.
Anti-hijack. Protection against robbery.
This function can be enabled or disabled at any time by programming.
If the feature is enabled by programming, it will be activated each time the ignition
turning on follows a door open and closed as well as each time someone opens a door
with ignition turned on and also remotely by pressing button 3 of the transmitter for 3
seconds. Thus, if a robber forces you to leave the car and give him the keys, obey: Anti-
hijack will trigger the alarm and block the engine.
A siren beep will confirm the Anti Hijack activation by switching the ignition on or
remotely, that will be followed by 2-minute pause with the LED flashing slowly. After the
pause, the siren will emit beeps during 30 seconds. After those 30 seconds of siren
signals the signal lights will begin to flash and the engine will be blocked. Starting from
this moment, the engine will be blocked until complete cancellation of Anti-hijack. In a
minute of blocking the engine the alarm system will begin 30-second alarming and will
repeat these 30 second alarming cycles until the ignition is switched off.
If a door is opened with the ignition turned on, this will cause the LED to flash for
30 seconds (but not 2 minutes), after that the above procedure will follow.
From the moment of Anti-hijack activation and until its complete cancellation, all
transmitters will be blocked and the system will not respond to any remote commands.
To cancel Anti-hijack within the 2-minute or 30-second (the second case) pause, enter
the first digit of your PIN code using the override switch. The LED will go out, the system
will revert to normal operation, one flash/beep signal will confirm the Anti Hijack has
been disarmed.
Note: as soon as you turn the ignition off without the Anti Hijack previously disarmed
the alarm system will warn you by double beeps.
To cancel Anti-hijack after the 2-minute or 30-second pause, you have to stop the car
and enter the full code, the same as while emergency disarming. If the full PIN code is
Ваш отзыв будет первым