Бесплатные инструкции на русском языке
  • Тип техники
  • Бренд

Просмотр инструкции автосигнализации Mongoose AMG-850C, страница 12

Mongoose
12
Technical specifications
Supply voltage 10...15 V
Power consumption in arm mode 20 mA
Radio channel frequency 433.92 MHz
Operating temperature range -40...+85
0
С
Upper current limit
- engine blocking circuits 300 mA
- signal light circuits 10 A
- central lock control circuits 15 A
- auxiliary output circuits 300 mA
Transmitter maximum range of coverage 30 m
Installation
Before you get down to connection, select locations in your car for the following
instruments and connections:
direct current source;
current source to be used with ignition on;
lights connection points (positive pulse);
door pin switches;
trunk pin switch;
hood pin switch (install an additional pin switch if necessary);
starter wire;
disconnect the «(« terminal of car battery.
Main 24-way connector.
BLACK WIRE
Connect to car body.
GREEN/BROWN WIRE
Electronic module power supply. Connect to 12V direct current source via a 5A fuse.
BLACK/WHITE and BLACK/GREEN WIRES
Relay outputs to lights. One wire is connected to the left side lights circuit, the other -
to the right side lights circuit.
GREEN and YELLOW WIRES
These wires are connected to the door pin switches. The connection layout depends
on whether positive or negative door pin switches are used.
Negative door pin switches:
connect the YELLOW wire to ground, the GREEN wire to the door wire between the
door pin switches and dorm light lamp, on which ground appears at doors opening.
Make sure that the selected wire is connected to all the car’s doors.
Positive door pin switches:
Connect the GREEN wire to the (+) terminal of the 12V power supply, the YELLOW wire
to the door wire between the door pin switches and dorm light lamp, on which 12V appears
at doors opening. Make sure that the selected wire is connected to all the car’s doors.
CAUTION! It is strongly prohibited to use the yellow and green wires simultaneously
as the system trigger inputs, i. e. there must be no simultaneous connection to the positive
and the negative door pin switches.
Ваш отзыв будет первым
Задайте вопрос
Ваше имя
E-mail
Вопрос*
Ваш вопрос будет опубликован после проверки
Ваш вопрос опубликован

Смотрите также другие инструкции раздела Mongoose