- Тип техники
- Бренд
Просмотр инструкции культиватора Al-ko MH 5005 R, страница 15
Safety instructions
441442_a 15
The machine must not be operated if the ope-
rator is under the influence of alcohol, drugs
or medication.
Observe local ordinances regarding opera-
ting times.
Work only when there is adequate daylight or
artificial lighting.
CAUTION!
Always perform a visual check prior to
start-up.
The equipment should be used only if in good
order and condition
Note that the user is responsible for accidents
and damage caused to other persons and/or
their property
Do not deactivate safety and protection de-
vices
Do not place your hands and feet close to any
rotating parts.
Never lift or carry the mower while the motor
is running
Always ensure stability when working.
The user is responsible for accidents invol-
ving other people and their property.
Do not leave the appliance unsupervised.
Keep the exhaust and motor clean
Store petrol in designated containers only.
Only refuel in open air.
Replace a damaged petrol tank and/or tank
cap.
Only replace damaged or worn parts by ge-
nuine spare parts.
Subject to changes in design and configura-
tion.
No one should be standing in front of the de-
vice and/or tiller blades when starting the mo-
tor - the tiller blade drive must be turned off.
When attaching and removing the transport
wheel and/or when adjusting the depth skid,
the motor must be turned off and the tiller bla-
des must be upright.
When moving the device using the attached
transport wheel, turn off the motor and wait
for the tiller blades to come to a standstill.
The device may only be operated by main-
taining the safety distance provided by the
handlebar.
Always operate parallel to the slope.
Do not operate the device up or down the
slope, as well as on slopes with a gradient of
more than 10°.
Do not open the tank cap or refuel with petrol
while the motor is still running and while the
machine is still hot.
Use a funnel or a filler pipe when refuelling so
that no fuel is spilled on the engine, the deck
or the ground.
Do not start the engine if petrol has over-
flowed. The appliance may be cleaned, and
any attempt at ignition may be made, only
when the petrol vapours have dissipated.
For safety reasons, never use the engine with
worn or damaged parts. Such parts must al-
ways be replaced, not repaired. Use OEM
spare parts. Spare parts of inferior quality can
damage the engine and endanger your safety
Renew exhaust silencers if damaged.
Do not change the engine governor settings.
ASSEMBLY
Assembly of depth skid (2)
Insert the long side of the depth skid (2-1) into
the end piece of the frame arm and lock it by
turning the handle (2-2).
Assembly of transport wheel (3)
The transport wheel (3-1) is used to transport the
cultivator.
Push the transport wheel (3-1) onto the depth
skid and secure it using the star screw (3-2).
Remove the transport wheel during operation:
Loosen the wing screw (3-2) and remove the
transport wheel.
Assembly of handlebar support (4)
Attach the support (4-1) to the cultivator using
the 4 screws (4-2) already positioned on the
plate along with the washers (4-3) and nuts
(4-4).
Attach the cable feed-through (4-5) as shown
in the figure (4).
Ваш отзыв будет первым