- Тип техники
- Бренд
Просмотр инструкции автомойки Karcher CB 2 25, страница 39
- 17
102 Roof brush limit 4 too long exceeded Cable, motor or gear of rotation roof
brush defective or vehicle of this type
cannot be washed
Drive vehicle out of the plant, switch off
main switch, wait for 10 seconds, switch
on main switch again, press Reset button,
press button Normal setting, repeat wash-
ing procedure.
103 Side brush 1 limit 4 too long exceeded Cable, motor or gear of rotation side-
brush 1 defective or vehicle of this type
cannot be washed
104 Side brush 2 limit 4 too long exceeded Cable, motor or gear of rotation side-
brush 2 defective or vehicle of this type
cannot be washed
105 Washing section takes too long Washing unit does not move during wash-
ing
Switch off and switch on the unit, repeat
washing process, call Customer Service
106 Maximum idling time of portal exceeded
107 Frequency converter of lifting motors,
switched off due to excess current in lift/
lower roof-brush
Lifting system of roof brush is difficult
to access
Check lifting system, switch off and switch
on the unit, repeat washing process, call
Customer Service
108 Frequency converter of lifting motors,
switched off due to excess current in lift/
lower drier
Lifting system of drier is difficult to access
109 Under-voltage has occurred Fluctuations in mains voltage Check power supply, switch on/ off the
unit, repeat washing process
110 Flow switch of brush washing has been
triggered
no water during brush washing Check supply of fresh and processed wa-
ter, repeat washing process
End switch for roof dryer, swivelling blade
does not transmit signal
Mechanical swivel device drags, end
switch defective.
Repair mechanical device, replace end
switch.
122 Switching bracket of roof drier is busy Check switching bracket and its limit
switch for damages
Repeat washing process, call Customer
Service
123 Short/ narrow hall side 1 front key has
been pressed
The switch has been pressed by a person Reset switch manually and press start key
on the wash card reader to continue with
washing
124 Short/ narrow hall side 1 rear key has
been pressed
125 Short/ narrow hall side 2 front key has
been pressed
126 Short/ narrow hall side 2 rear key has
been pressed
127 Vehicle to broad on side 1 key has been
pressed
Vehicle is too broad or has been posi-
tioned much to the left
Reposition the vehicle, reset the switch
manually, continue with washing by press-
ing the start key at the wash card reader or
repeat washing process
128 Vehicle to broad on side 2 key has been
pressed
Vehicle is too broad or has been posi-
tioned much to the right
139 Protective motor switch of fresh water
pump was triggered
Protective motor switch in the pump
switching cabinet was triggered
Switch on the protective motor switch
again, repeat washing process, call Cus-
tomer Service
141 Fault in frequency converter of lifiting mo-
tors, switched off while operating roof
brush
Lifting system of roof brush is difficult
to access
Check lifting system, switch off and switch
on the unit, repeat washing process, call
Customer Service
142 Fault in frequency converter of lifiting mo-
tors, switched off while operating drier
Lifting system of drier is difficult to ac-
cess
143 Fault in intensive cleaner Protective motor switch in the pump
switching cabinet was triggered
Switch on the protective motor switch
again, repeat washing process, call Cus-
tomer Service
144 Fault in processed water Fault in water preparation Check processed water tank and water
preparation; an on-going wash is complet-
ed using fresh water, the error must be quit
by pressing the emergency stop; an emer-
gency operation can be driven using fresh
water until the water preparation has been
repaired; call Customer Service
145 Fault in fresh water Dry run of fresh water tank Check fresh water tank, check main water
pressure; repeat washing process, call
Customer Service
146 Fault in osmosis water Osmosis water tank empty; osmosis
plant is dective
Check osmosis plant, call Customer Serv-
ice
147 Fault in rim cleaner Protective motor switch in the pump
switching cabinet was triggered
Switch on the protective motor switch
again, repeat washing process, call Cus-
tomer Service
Display Fault Possible cause Remedy
39EN
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
Посетитель_Ze55of
13 июля 2022, Новосибирская
ИНСТРУЦИЮ К ЭКСПЛУАТАЦИИ
0 ответов
Ответить
0