- Тип техники
- Бренд
Просмотр инструкции автомойки Karcher CB 1 25 Eco, страница 34
- 15
107 Frequency converter of lifting motors,
switched off due to excess current in lift/
lower roof-brush
Lifting system of roof brush is difficult to
access
Check lifting system, switch off and switch
on the unit, repeat washing process, call
Customer Service
108 Frequency converter of lifting motors,
switched off due to excess current in lift/
lower drier
Lifting system of drier is difficult to access
109 Under-voltage has occurred Fluctuations in mains voltage Check power supply, switch on/ off the
unit, repeat washing process
110 Flow switch of brush washing has been
triggered
no water during brush washing Check supply of fresh and processed wa-
ter, repeat washing process
122 Control handle of drier allocated Check switching bracket and its limit
switch for damages
Repeat washing process, call Customer
Service
123 Short/ narrow hall side 1 front key has
been pressed
The switch has been pressed by a person Reset switch manually and press start key
on the wash card reader to continue with
washing
124 Short/ narrow hall side 1 rear key has
been pressed
125 Short/ narrow hall side 2 front key has
been pressed
126 Short/ narrow hall side 2 rear key has
been pressed
127 Vehicle to broad on side 1 key has been
pressed
Vehicle is too broad or has been posi-
tioned much to the left
Reposition the vehicle, reset the switch
manually, continue with washing by press-
ing the start key at the wash card reader or
repeat washing process
128 Vehicle to broad on side 2 key has been
pressed
Vehicle is too broad or has been posi-
tioned much to the right
139 Protective motor switch of fresh water
pump was triggered
Protective motor switch in the pump
switching cabinet was triggered
Switch on the protective motor switch
again, repeat washing process, call Cus-
tomer Service
141 Fault in frequency converter of lifiting motors,
switched off while operating roof brush
Lifting system of roof brush is difficult to
access
Check lifting system, switch off and switch
on the unit, repeat washing process, call
Customer Service
142 Fault in frequency converter of lifiting mo-
tors, switched off while operating drier
Lifting system of drier is difficult to access
143 Fault in intensive cleaner Protective motor switch in the pump
switching cabinet was triggered
Switch on the protective motor switch
again, repeat washing process, call Cus-
tomer Service
144 Fault in processed water Fault in water preparation Check processed water tank and water
preparation; an on-going wash is complet-
ed using fresh water, the error must be quit
by pressing the emergency stop; an emer-
gency operation can be driven using fresh
water until the water preparation has been
repaired; call Customer Service
145 Fault in fresh water Dry run of fresh water tank Check fresh water tank, check main water
pressure; repeat washing process, call
Customer Service
146 Fault in osmosis water Osmosis water tank empty; osmosis plant is
dective
Check osmosis plant, call Customer Service
147 Fault in rim cleaner Protective motor switch in the pump
switching cabinet was triggered
Switch on the protective motor switch
again, repeat washing process, call Cus-
tomer Service
148 Filling level of foam too low Detergent container almost empty refill the corresponding detergent
149 Filling level of shampoo too low
150 Filling level of drying aid too low
151 Filling level of hot wax too low
152 Filling level of insect cleaner too low
153 Filling level of polish too low
154 Filling level of chemicals 2 too low
155* Lack of water supply to high pressure
pumps
Water supply tank for high pressure
pumps empty
Check water tank, repeat washing proc-
ess, call Customer Service
156* Protective motor switch high pressure
pump 1 was triggered
Protective motor switch in the pump
switching cabinet was triggered
Switch on the protective motor switch
again, repeat washing process, call Cus-
tomer Service
157* Protective motor switch high pressure
pump 2 was triggered
159* Thermal switch high pressure pump 1 was
triggered
Motor of high pressure pump 1 too hot or
defective
Repeat washing process, emergency op-
eration possible by using the second high
pressure pump, call Customer Service
160* Thermal switch high pressure pump 2 was
triggered
Motor of high pressure pump 2 is too hot
or defective
Repeat washing process, emergency op-
eration with first high pressure pump is
possible, call Customer Service
34 EN
Ваш отзыв будет первым