- Тип техники
- Бренд
Просмотр инструкции материнской платы Gigabyte GA EX58 UD5 rev 1 0, страница 99
Appendix- 99 -
5-1-3 Making a SAT A RAID/AHCI Driver Diskette
(Required for AHCI and RAID Mode)
To successfully install operating system onto SA TA hard drive(s) that is/are configured to RAID/AHCI
mode, you need to install the SATA controller driver during the OS installation. Without the driver , the
hard drive may not be recognized during the Windows setup process. First of all, copy the driver for
the SATA controller from the motherboard driver disk to a floppy disk. For installing W indows Vista, you
also can copy the SATA controller driver from the motherboard driver disk to a USB flash drive. See the
instructions below about how to copy the driver in MS-DOS mode
(Note 1)
. Prepare a startup disk that has
CD-ROM support and a blank formatted floppy disk.
Step 1: Insert the prepared startup disk and motherboard driver disk in your system. Boot from the
startup disk. Once at the A:\> prompt, change to your optical drive (example: D:\>). At the D:\> prompt,
type the following two commands. Press <Enter> after each command (Figure 1):
cd bootdrv
menu
Step 2: When the controller menu (Figure 2) appears, remove the startup disk and insert the blank
formatted disk. Select the controller driver by pressing the corresponding letter from the menu and press
<Enter>. For example, from the menu in Figure 2, for Intel ICH10R SA TA controllers, select 1)Intel
Matrix Storage driver for 32bit system for Windows 32-bit operating system
or 2)Intel Matrix
Storage driver for 64bit system for Windows 64-bit
(Note 2)
. Your system will then automatically zip and
transfer this driver file to the floppy disk. Press any key to exit when finished.
(Note 1) For users without a startup disk:
Use an alternative system and insert the motherboard driver disk. From your optical drive
folder, double click the Menu.exe file in the BootDrv folder (Figure 3). A command prompt
window will open similar to that in Figure 2.
(Note 2) The GIGABYTE GSATA drivers in the menu in Figure 2 are required if you want to install
the Windows operating system onto hard drives that are connected to the GIGABYTE SATA2/
JMB322 controller and configured to AHCI mode in BIOS Setup. For installation of the driver
during the OS installation, refer to section 5-1-4.
Figure 1 Figure 2
Figure 3
Ваш отзыв будет первым