- Тип техники
- Бренд
Просмотр инструкции материнской платы Gigabyte GA 73PVM S2H rev 1 0, страница 73
Appendix- 73 -
Chapter 5 Appendix
(Note 1) Skip this step if you do not want to create RAID array on the SA TA controller.
(Note 2) Required when the SATA controller is set to AHCI or RAID mode.
5 - 1 Configuring SATA Hard Drive(s)
To configure SATA hard drive(s), follow the steps below:
A. Install SATA hard drive(s) in your computer .
B. Configure SATA controller mode in BIOS Setup.
C. Configure a RAID array in RAID BIOS.
(Note 1)
D. Make a floppy disk containing the SATA RAID/AHCI driver.
(Note 2)
E. Install the SATA RAID/AHCI driver and operating system.
(Note 2)
Before you begin
Please prepare:
• At least two SATA hard drives (to ensure optimal performance, it is recommended that you use
two hard drives with identical model and capacity). If you do not want to create RAID, you may
prepare only one hard drive.
• An empty formatted floppy disk.
• Windows Vista/XP setup disk.
• Motherboard driver disk.
5-1-1 Configuring the Onboard SATA Controller
A. Installing SATA hard drive(s) in your computer
Attach one end of the SA TA signal cable to the rear of the SA TA hard drive and the other end to an
available SATA port on the motherboard. Then connect the power connector from your power supply
to the hard drive.
Ваш отзыв будет первым