- Тип техники
- Бренд
Просмотр инструкции материнской платы Gigabyte GA 8I945GMH RH, страница 73
Appendix- 73 -
English
(4) Making a SATA Driver Disk
To install operating system onto a serial ATA hard disk successfully, you need to install the SATA
controller driver during OS installation. Without the driver, the hard disk may not be recognized during
the Windows setup process. First of all, copy the driver for the SATA controller from the motherboard
driver CD-ROM to a floppy disk. See the instructions below about how to copy the driver in MS-DOS
mode
(Note1)
. Prepare a startup disk that has CD-ROM support and a blank formatted floppy disk.
Step 1: Insert the prepared startup disk and motherboard driver CD-ROM in your system. Boot from the
startup disk. Once at the A:\> prompt, change to the CD-ROM drive (example: D:\>). At the D:\>
prompt, type the following two commands. Press ENTER after each command (Fig.12):
cd bootdrv
menu
(Note 1) For users without a startup disk:
Use an alternative system and insert the GIGABYTE motherboard driver CD-ROM. From the
CD-ROM drive folder, double click the MENU.exe file in the BootDrv folder (Figure 14). A
command prompt window will open similar to that in Fig. 13.
Fig.12
Fig. 13
Step 2: When the controller menu (Fig.13) appears, remove the startup disk and insert the blank
formatted disk. Select the controller driver by pressing the corresponding letter from the menu.
For example, from the menu in Figure 13, press 7 to select Intel Matrix Storage Manager 32 bit for
Windows operating system
(Note 2)
. Your system will then automatically zip and transfer this driver file to
the floppy disk. Press 0 to exit when finished.
Fig. 14
(Note 2) For 64-bit Windows Operating System, please select Intel(R) Matrix Storage Manager
64bit.
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
Гость
02 июня 2020, Петрозаводск
Пидарасы, в каком месте у вас инструкция РУССКОМ ЯЗЫКЕ?
0 ответов
Ответить
0