- Тип техники
- Бренд
Просмотр инструкции пылесоса Philips FC6400, страница 10
4 Remove the housing of the appliance. (Fig. 7)
5 Remove the motor unit and the suction part (Fig. 8).
6 Undo the 4 screws that keep the battery compartment cover in place (Fig. 9).
7 Remove the battery compartment cover (1) and take out the battery pack (2). Then disconnect the
battery pack from the appliance (Fig. 10).
Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support for a list
of frequently asked questions or contact the Consumer Care Center in your country.
Problem
Possible cause Solution
The appliance does not
work when I push the
button.
The battery light flashes fast
because the batteries are
low.
To charge the batteries, insert the small
plug into the socket on the appliance
and insert the adapter into a wall socket.
You cannot use the
appliance because the
appliance is still charging.
You have to remove the small plug from
the socket on the appliance before you
can switch on the appliance.
You have to press two
buttons.
First press the on/off button to switch
on the appliance. Then press the MAX
button to get maximum suction power.
The appliance has a lower
suction power than usual.
The filter and the cyclone are
dirty.
Clean the filter and the cyclone.
You have not connected the
dust bucket, the dust
separator and the cyclone
properly. Incorrect assembly
of these parts causes air
leakage, which leads to loss
of suction power.
Connect the dust bucket, the dust
separator and the cyclone properly.
Dust escapes from the
appliance.
The filter is dirty. Clean the filter.
The brush does not turn
anymore.
The brush encounters too
much resistance.
Clean the brush with a pair of scissors or
by hand. If you clean the roller brush by
hand, pull the hairs or threads from the
widest side to the narrowest side of the
roller brush (see user manual).
The water flow from the
water tank is reduced
The wetting strip is blocked
by excessive residue.
Remove the wetting strip and clean it.
The microfiber mopping pad
is not placed correctly. It
covers the wetting strip and
blocks the water flow from
the wetting strip.
Make sure that the Velcro strips on the
mopping pad and the Velcro strips on
the water tank are perfectly aligned.
Also make sure the striped side of the
mopping pad is facing outwards, away
from the bottom of the water tank.
10
English
Ваш отзыв будет первым